Simple Serial Interface (SSI) Options
The SSI Options bar codes are directed toward the host programmer when writing host/scanner interface programs for different hosts. Contact Customer Support (page
Note: Baud Rate Parameter must remain at 9600 bps at all times.
SSI Defaults
The SSI Options bar codes are directed toward the host programmer when writing host/scanner interface programs for different hosts.
Option | Default Value |
|
|
Baud Rate | Not Supported |
|
|
Beep on < BEL > | Supported |
|
|
Check Parity | Not Supported |
|
|
Decode Data Packet Format | Unpacketed |
|
|
Host Character | 200 msec |
|
|
Host Serial Response Time out | 2 sec |
|
|
Intercharacter Delay | 0 |
|
|
Parity | None |
|
|
Software Handshaking | Enable |
|
|
Stop Bit Select | 1 |
|
|
Beep on BEL
This parameter is enabled. There is no corresponding programming bar code required.
Baud Rate
Baud rate is the number of bits of data transmitted per second. The scanners baud rate setting should match the data rate setting of the host device. If not, data may not reach the host device or may reach it in distorted form.
Baud rate should always be set to 9600. If the baud rate is set to any other value but 9600, a transmit error will occur. Either scan the 9600 bps bar code or reset the mobile device to factory default (or last saved good default) values.
Set this parameter by scanning this bar code.
9600 bps
The SSI Options bar codes are directed toward the host programmer when writing host/scanner interface programs for different hosts. Contact Customer Support (page
4 - 18