NOTIS Editing

When enabled, the start and stop characters are stripped from a decoded Codabar symbol. Set this parameter by scanning either of the bar codes shown below.

Enable NOTIS Editing

* Disable NOTIS Editing

Set Lengths for Codabar

L1 Default: 5

L2 Default: 55

Lengths for Codabar may be set for:

•any length,

•one or two discrete lengths,

•or lengths within a specific range.

The length of a code refers to the number of characters, including check digits, the code contains. It also includes any start or stop characters.

See the table titled ASCII Character Equivalents (page 9-2)

One Discrete Length (Parameter L1)

This option decodes only those codes containing a selected length. For example, when you want to scan only Codabar symbols containing 14 characters, scan the “Codabar One Discrete Length” bar code and then “1” and “4” bar codes using the Keypad Number Symbols (page 4-72).

To begin setting one discrete length, scan this bar code:

Next, scan two numeric bar codes that correspond to the desired value. Single digit numbers must have a leading zero. If you wish to change your number selection, scan Cancel on Keypad Number Symbols (page 4-72).

4 - 28