3

Bluetooth Module Programming Bar Codes

Introduction

Bar codes in this section are designed to be read by a ring scanner or ring imager connected to the Bluetooth Ring Scanner module.

This section contains programming bar codes to be used when programming the Bluetooth Ring Scanner module only. The bar codes were created using Code 128 ASCII. An asterisk (*) next to an option indicates the default setting. Honeywell scanners and imagers are setup to read Code 128 bar codes by default.

•The ring scanner, that is a part of the Bluetooth Ring Scanner product, has an SE955 scan engine. Use 1D Laser Scanner Programming Bar Codes (page 4-1)to program the ring scanner engine parameters.

•The ring imager, that is a part of the Bluetooth Ring Scanner product, has an SE4400 scan engine. Use 2D Laser Imager Programming Bar Codes (page 5-1)to program the ring imager scan engine parameters.

Preparation

Assemble the Bluetooth Ring Scanner components.

Connect a ring decoder to the Bluetooth Ring Scanner module before inserting a battery into the module. The Bluetooth Ring Scanner module performs initialization with the Ring Scanner on bootup. A fully charged battery must be secured in the module battery well.

A ring scanner or ring imager can be tethered to the Bluetooth Ring Scanner module. Either ring device can be used to read the Bluetooth Ring Scanner module programming bar codes in this section.

When parameters are changed, and saved to memory, the Bluetooth Ring Scanner module LED blinks. Bar codes cannot be scanned until the LED color returns to normal mode.

The scan engine manufacturer may offer more bar codes and options than are contained in this guide. Note that the bar codes in this guide are only those supported by Honeywell and the imagers or scanners linked to mobile devices that Honeywell manufactures or supports. Contact Customer Support (page 10-1)if you need help when using the bar codes in this guide.

Module Programming Bar Codes

To change a parameter value scan the appropriate bar code in this section. The new value replaces the default value in memory. An asterisk (*) next to an option in this section indicates the default setting.

Bluetooth Ring Scanner Module Factory Default Settings

Pairing Status (page 3-3)

Slave Mode Enabled

 

 

Suspend Timeout (page 3-4)

5 minutes

 

 

Beep on Reconnect (page 3-5)

Enabled

 

 

Reconnect Timeout (page 3-7)

30 seconds

 

 

Reconnect Timeout (page 3-7)

1 minute

 

 

Role Switching (page 3-8)

Enabled

 

 

Authentication (page 3-9)

Disabled

 

 

Encryption (page 3-9)

Disabled

 

 

PIN Code (page 3-12)

16 zeros

 

 

Friendly Name (page 3-13)

“LXE Scanner” + Module MAC address

 

 

Ring Imager Focus Mode (page 3-11)

Smart Focus

 

 

Beep Volume (page 3-10)

High

 

 

Note: Imager White LED programming bar codes have been replaced by the bar codes in Decoding Illumination (page 5-8)and LED Illumination (page 5-10).

3 - 1