Code 93

Default:

Disable Code 93

•L1 Default : 4

•L2 Default: 55

When enabled, Code 93 symbols will be scanned, decoded and transmitted.

Set this parameter by scanning either of the bar codes shown below.

Enable Code 93

* Disable Code 93

Set Lengths for Code 93

L1 Default: 4 L2 Default: 55

Lengths for Code 93 may be set for:

any length,

one or two discrete lengths,

or lengths within a specific range.

The length of a code refers to the number of characters, including check digits, the code contains.

See the table titled ASCII Character Equivalents (page 9-2).

One Discrete Length (Parameter L1)

This option decodes only those codes containing a selected length. For example, when you want to scan only Code 93 symbols containing 14 characters, scan the “Code 93 One Discrete Length” bar code and then “1” and “4” bar codes using the Imager Keypad Number Symbols (page 5-81).

To begin setting one discrete length, scan this Code 93 One Discrete Length bar code:

Next, scan two numeric bar codes that correspond to the desired value. Single digit numbers must have a leading zero. To correct an error or to change a selection, scan Cancel on the “Imager Keypad Number Symbols” page.

5 - 45