Aiming Modes

There are many aiming “modes” for laser bar code scanners – aiming dots, aiming patterns, aim duration, etc. All aiming “modes” concern the length of time the beam is sent out, how wide the beam is and what happens when the timer expires. The terms are used interchangeably and may be confusing for the novice bar code laser scanner user.

Note: Decoding algorithms released by the bar code engine manufacturer often change upon each new release. Programming parameters that were available at one release may not be available upon a later software release. Honeywell supports the programming bar codes for the specific engines in this guide only.

SE955 Ring Scanner

The scan engine can have it's aiming beam/aiming dot setup using these bar codes:

Use Laser On Time (page 4-14)

Aim Duration (page 4-7),and

Scan Angle (SE955 only) (page 4-17)

Aiming Dot Help

How to get an aiming dot when there is no “Aiming Dot” parameter:

Set Aim Duration to .5 seconds and an aiming “dot” is sent while the scan trigger is held down. When the timer expires, the aiming beam widens and the bar code is read.

Prefix / Suffix

Ring decoder engine prefix and suffix parameters should not be set, changed, or reset using the Prefix and Suffix bar codes shown in this section. When the Bluetooth Ring Scanner module is reset to defaults, the prefix and suffix settings revert to their default values and need to be scanned again. Use the ScanWedge / ScanWedge NGW Power Tool (Dolphin 70e) or Data Collection / Scanner control panel (all others) in the host computer to store prefix and suffix values.

Refer to the host user guide (e.g., Thor VM2) for information and instruction on setting up the following scanner parameters:

Enable/Disable decoding sounds

Imager LED Illumination

COM1 Serial Parameters

Code ID: AIM, Symbol, Custom

Symbology Settings including Prefix/Suffix

Control Character Mapping

Custom Identifiers

Pre-Configured Default Values

Ring Scanner Setting 955

Default

 

 

Set Default Parameter (page 4-6)

All Defaults

 

 

Scanning Options

 

 

 

Aim Duration (page 4-7)

0.0 sec

 

 

Aiming Mode

Not Supported

 

 

Beeper Volume

Not Supported

 

 

Bi-Directional Redundancy (page 4-7)

Disable

 

 

Laser On Time (page 4-14)

3.0 sec.

 

 

Linear Code Type Security Level (Redundancy Level) (page

1

4-15)

 

 

 

Parameter Pass Through (page 4-16)

Disable

 

 

Parameter Scanning (page 4-16)

Enable

 

 

Power Mode (page 4-17)

Low Power

 

 

Raster Expansion Rate

Not Supported

 

 

Raster Height

Not Supported

 

 

4 - 2