NOTIS Editing

When enabled, the start and stop characters are stripped from a decoded Codabar symbol.

Set this parameter by scanning either of the bar codes shown below.

Enable NOTIS Editing

* Disable NOTIS Editing

Set Lengths for Codabar

L1 Default: 5

L2 Default: 55

Lengths for Codabar may be set for:

any length,

one or two discrete lengths,

or lengths within a specific range.

The length of a code refers to the number of characters, including check digits, the code contains. It also includes any start or stop characters.

See the table titled ASCII Character Equivalents (page 9-2).

One Discrete Length (Parameter L1)

This option decodes only those codes containing a selected length. For example, when you want to scan only Cod- abar symbols containing 14 characters, scan the Codabar One Discrete Length bar code and then “1” and “4” bar codes using the Imager Keypad Number Symbols (page 5-81).

To begin setting one discrete length, scan this Codabar One Discrete Length bar code:

Next, scan two numeric bar codes that correspond to the desired value. Single digit numbers must have a leading zero. To correct an error or to change a selection, scan Cancel on the Imager Keypad Number Symbols page.

5 - 57