5

2D Laser Imager Programming Bar Codes

Introduction

These bar codes, explanations and instructions are for programming the SE4400 laser imager engine in your ring imager. Do not scan the bar codes in this section with any other imager or laser engine.

Note: A ring imager does not have beep / audio capability.

Assumption: The user is familiar with Windows on-screen functions.

Scan engine manufacturers may offer more bar codes and options than are contained in this chapter. Note that the bar codes in this chapter are only those supported by Honeywell and the mobile devices it manufactures or supports. ContactCustomer Support (page 10-1)if you need help when using the bar codes in this chapter.

To change a parameter value scan the appropriate bar code in this chapter. The new value replaces the standard default value in memory.

An asterisk (*) next to an option indicates the default setting.

Using the imager like a camera (or for OCR decoding) is not supported in this release.

The following SE4400 bar code symbologies are supported:

Symbology

Codabar

Aztec / Aztec Inverse

 

 

Code 11

PDF417

 

 

Code 128

MicroPDF

 

 

Code 39

Code 128 Emulation

 

 

Code 93

Data Matrix / Data Matrix

 

Inverse

 

 

Composites

Maxicode

 

 

Discrete 2 of 5

MicroQR

 

 

Interleaved 2 of 5

QR Code / QR Inverse

 

 

MSI Plessey

GS1 DataBar (RSS)

 

 

UPC / EAN

Postal Codes

 

 

Note: The default value for all Postal Code symbologies is “Enabled.” For best performance when reading a specific postal symbology, all other postal symbologies should be disabled.

Note: Prefix / Suffix

Ring decoder engine prefix and suffix parameters should not be set, changed, or reset using the Prefix and Suffix bar codes shown in this section. When the Bluetooth Ring Scanner Module is reset to defaults, the prefix and suffix settings revert to their default values and need to be scanned again. Use the ScanWedge / ScanWedge NGW Power Tool (Dolphin 70e) or Data Collection / Scanner control panel (all others) in the host computer to store prefix and suffix values.

Refer to “Scanner” or “Data Collection” in the host User’s Guide (e.g., Thor VM1) for information and instruction on setting up the following ring imager parameters:

•Enable/Disable decoding sounds

•Imager LED Illumination

•COM1 Serial Parameters

•Code ID: AIM, Symbol, Custom

•Symbology Settings including Prefix/Suffix

•Control Character Mapping

•Custom Identifiers

•Pre-Configured Defaults

5 - 1