HP 3150, 3100 manual Commands Comments Appropriate responses

Table 21. Appropriate responses

Commands		Comments	Appropriate responses
(NSF) (CSI) DIS		Identifying capabilities: from a manual receiver	(NSC) (CIG) DTC
		or an auto-answer unit	(TSI) DCS
			(NSF) (CSI) DIS
			(CRP) (TSI) (NSS)
			(PWD) (SEP) (CIG) DTC
			(PWD) (SUB) (TSI) DCS
(NSC) (CIG) DTC		Mode setting command: from calling unit	(TSI) DCS
			(NSF) (CSI) DIS
(PWD) (SEP) (CIG) DTC		Poll operation	(CRP) (TSI) (NSS)
(TSI) DCS		Mode setting command: from manual	CFR
(TSI) (NSS)		transmitter or automatic receiver	FTT
			(NSC) (CIG) DTC
(PWD (SUB) (TSI) DCS		This command is always followed by phasing/	(NSC) (CIG) DTC
		training.
CTC		Mode setting command: from the transmitter to	(CTR)
		the receiver	(CRP)
(EOR-NULL)		Indicates the next block transmission from the	(ERR)
		transmitter to the receiver	(RNR)
			(CRP)
Any one of the following:		The receiver	(ERR)
z	(EOR-EOP)		(RNR)
z	(EOR-EOM)		PIN
z (EOR-PRI-MPS)			(CRP)
z (EOR-PRI-EOP)
z (EOR-PRI-EOM)
Any one of the following:		Post-message commands	MCF
z	MPS		RTP
z	EOP		RTN
z	EOM		PIP
z	(PRI-MPS)		PIN
			(CRP)
z	(PRI-EOP)
z	(PRI-EOM)
(PPS-NULL)		Post-message command for a partial page	(PPR)
		from the transmitter to the receiver	MCF
			(RNR)
			(CRP)
Any one of the following:		Post-message commands for a complete page	(PPR)
z	(PPS-MPS)	from the transmitter to the receiver	MCF
z	(PPS-EOP)		(RNR)
z	(PPS-EOM)		PIP
z	(PPS-PRI-MPS)		PIN
			(CRP)
z (PPS-PRI-EOP)
z (PPS-PRI-EOM)
(RR)		Ask for the status of the receiver: from the	(RNR)
		transmitter to the receiver	(ERR)
			MCF
			PIP
			PIN
			(CRP)
DCN		Phase E command	None

EN Fax trace report 203