HP 3100, 3150 manual No Memory for, Report, Erase/Print, Document, Not Enough Memory, Copy job

Table 9. Control panel messages

Message Cause Solution

No Memory for	There is not enough memory to print a
Report	report because memory is being used to
Erase/Print	store faxes that have been received to
Document	memory.
	There is not enough memory to print a
	report because memory is being used to
	store faxes set up to be sent at a future
	time or to be polled.

Print faxes that have been received to memory.

If you have several faxes set up to be sent at a future time or to be polled, try clearing these faxes using job status.

No Modem Installed There is a problem with the line interface unit (LIU).

Unplug the power cord from the power source, wait 10 seconds, and replug in the power cord.

Connect the product to a different power source.

If the error persists, see Chapter 6, “Troubleshooting.”

No Room in Fax Log The fax log was unable to print because of an error; for example, the product is out of paper.

Solve the error condition so that the product can print the fax log.

Not Enough Memory There is not enough memory to complete the job indicated.

Try again to send the job. If the error persists, press and hold STOP/CLEAR for seven seconds to reset the product.

Not Enough Memory	The HP LaserJet 3100/3150 product does
to Duplicate for	not have enough memory to complete the
COPY	copy job.

Divide the copy job into smaller sections and then try again to copy.

Use the Document Assistant to complete the copy job.

No Fax Pages in	The HP LaserJet 3100/3150 product
Memory to Reprint	attempted to execute “Reprint Last Fax”
	when nothing was in memory.

Wait for a fax, then as soon as a fax is in the memory, the HP LaserJet 3100/ 3150 product will reprint the fax.

Nov-22-93 06:30 PM (An incorrect date appears.)

The battery inside the HP LaserJet 3100/ 3150 product has failed, causing all Menu features to revert to the factory settings.

Settings that contained alphabetic and numeric characters you entered, such as header information and speed-dial names and numbers, have been erased.

The battery should be replaced. You can continue to use the HP LaserJet 3100/ 3150 product without replacing the battery, but any information you enter will be erased again if power is lost.

46 Installation and operation EN