HP 3150, 3100 Paper Bin is Empty, Please Add Paper, Password must be, Digits, Paused Memory, Full

Table 9. Control panel messages

Message	Cause	Solution
Paper Bin is Empty	The paper input bin is empty.	Load paper. If paper is already loaded,
Please Add Paper		remove it. Check for and remove any
		jammed sheets and discard them. Then,
		reload the paper stack in the paper input
		bin.
Password must be 4	An attempt was made to enter a password	Re-enter four-digit password.
Digits	that was not four digits.

Paused (Memory	The HP LaserJet 3100/3150 product
Full)	memory is full, and the current job in the
	document feeder tray is paused to wait for
	memory to become available.

Reduce activity on the HP LaserJet 3100/3150 product, or wait for other jobs to finish so that memory will be freed. If there are faxes set up to be polled or sent at a future time, you may want to cancel these jobs to free memory.

PC Not Detected	If you tried to send a document to an e-
Address Invalid	mail address in a one-touch key, speed-
	dial code, group-dial code, or to one that
	you entered manually at the control panel,
	the product must be directly connected to
	a computer using a parallel cable, the
	computer must be on, and a compatible e-
	mail program must be installed on the
	computer.

Make sure that the parallel cable is securely connected between the computer and the HP LaserJet 3100.3150 product.

Make sure that the computer is on. Make sure that a compatible e-mail program and the JetSuite Pro software are installed on the computer.

PC Print Timed Out The print job took too long to print, and the HP LaserJet 3100/3150 product timed out.

Let the “print jobs retry” continue for five minutes. If the HP LaserJet 3100/3150 product still does not print, cancel the current print job and resend it.

Phone Number Error Too many characters were entered when dialing a phone number.

The maximum number of characters that can be entered is 60. If you have a number longer than 60 characters, break the number into smaller chunks. Enter the first part of the number, and press REDIAL/PAUSE as the last character in the first number. Then, enter the second part of the number as if it were a second number going to a group. When the product dials, it will treat both numbers as if they are one.

EN Control panel 47