HP 3100, 3150 manual Formatter board removal 1

Formatter board

1Remove all covers and the RFI shield.

2If the LIU board has not been removed from the product, pull out slightly the connector for the flat, flexible cable (callout 1) at the left side of the formatter board to release the cable, and then disconnect the cable from the formatter board.

3Pull out slightly the connector for the flat, flexible cable (callout 2) at the bottom of the formatter board to release the cable, and then disconnect the cable from the formatter board.

Note	Both flat, flexible cables must be reinstalled to the same orientation.
	Examine the cables and make notes about their orientations to make
	sure that you reinstall them correctly.

1

2

Figure 36. Formatter board removal (1 of 2)

108 Removal and replacement EN