Configuration Options

Network Interface Configuration Options

Table C-1. Network Interface Configuration Options (1 of 2)

Line Framing Format: ESF (Factory 1) D4 (Factory 2)

D4 ESF

The framing format to be used on the network interface.

D4 – Configures for the D4 framing format.

ESF – Configures for the Extended Superframe format.

Line Coding Format: B8ZS (Factory 1) AMI (Factory 2)

AMI B8ZS

The line coding format to be used on the network interface.

AMI – Configures for the Alternate Mark Inversion coding format.

B8ZS – Configures for the Bipolar 8 Zero Suppression coding format.

Bit Stuffing: 62411

62411 Disable

Determines when bit stuffing is performed to meet the ones density requirements for data transmission on the network.

62411 – Specifies that a one be inserted in the data stream after 15 consecutive zeros or when the density of ones falls below 12.5% (complies with AT&T TR 62411).

Disable – Disables bit stuffing so that ones density is not enforced.

NOTES: – To comply with Canadian DOC CS-03 regulations, equipment installed in Canada must be configured to select 62411.

This configuration option is only available if the network interface line coding format is set to AMI.

Line Build Out (LBO): 0.0 0.0 –7.5 –15 –22.5

The line build out (LBO), in decibels, for the signal transmitted to the network.

Management Link: Disable

Enable Disable

Specifies whether Facility Data Link (FDL) is enabled. Selecting Enable allows SNMP or Telnet traffic to flow over the

4 kbps data link provided by FDL. Running SNMP or Telnet over FDL requires an end-to-end FDL connection and cannot be terminated within the network.

Enable – Enables the FDL management link for SNMP or Telnet.

Disable – Disables the FDL management link.

NOTES: – This configuration option is only available if the framing format is set to

ESF.

This configuration option is not available if EDL is enabled.

If the local DSU/CSU’s FDL is enabled, the remote DSU/CSU’s FDL must also be enabled.

C-2

August 2000

3162-A2-GB20-40

Page 100
Image 100
HP 3162 manual Table C-1. Network Interface Configuration Options 1, D4 ESF, AMI B8ZS