HP 3162 manual Device Health and Status, Health and Status Messages 1 Description

Monitoring and Testing

Device Health and Status

Use the System and Test Status screen to display the current health and status messages for the DSU/CSU. Table 5-2 lists these messages in priority order.

"Procedure

To display health and status messages:

1.From the Main Menu screen, select Status.

2.From the Status screen, select System and Test Status.

Table 5-2. Health and Status Messages (1 of 2)

Message	Description
AIS at DTE	An Alarm Indication Signal is being received by the DTE
	Drop/Insert (DSX-1) interface.
AIS at Network	An Alarm Indication Signal (unframed all ones signal) is being
	received by the network interface.
Device Fail	An internal error has been detected by the operating software. An

xxxxxxxx8-digit code appears for use by service personnel. The condition is cleared by resetting the device.

Download Failed	A download attempt was interrupted and failed to complete. The
	condition is cleared by resetting the device.
EER at Network	An Excessive Error Rate condition has been detected on the
	network interface. The condition is cleared when the error rate
	falls below the threshold value.
EER at Port n	The error rate of the received signal has exceeded the configured
	threshold for data port Port n (where n is the port number). This
	condition only occurs if the synchronous data port’s Embedded
	Data Link (EDL) is enabled. The condition is cleared when the
	error rate falls below the synchronous data port’s configured
	threshold value.
Ethernet Down	There is no electrical activity on the 10BaseT port.
LOS at DTE	A Loss Of Signal condition (175 consecutive zeros) has been
	detected on the DTE Drop/Insert (DSX-1) interface. The condition
	is cleared when the density of ones to zeros received is 12.5%.

LOS at Network

A Loss Of Signal condition (175 consecutive zeros) has been detected on the network interface. The condition is cleared when the density of ones to zeros received is 12.5%.

Modem Connected	The integral modem is currently connected. This message is only
	displayed for standalone DSU/CSUs.
Network Com Link	The network communication link is in a down state. This condition
Down	only occurs if the COM port is configured for Mgmt, and
	communication between the management system and the
	DSU/CSU is not currently possible for this port.

3162-A2-GB20-40 August 2000 5-3