￿The Y–register (press ) contains the previous estimate for the root or equals to zero. This number should be the same as the value in the X–register. If it is not, then the root returned was only an approximation, and the values in the X– and Y–registers bracket the root. These bracketing numbers should be close together.

￿The Z– register (press again) contains D-value of the equation at the root. For an exact root, this should be zero. If it is not zero, the root given was only an approximation; this number should be close to zero.

If a calculation ends with the   , the calculator could not converge on a root. (You can see the value in the X–register — the final estimate of the root — by pressing or to clear the message.) The values in the X– and Y–registers bracket the interval that was last searched to find the root. The Z–register contains the value of the equation at the final estimate of the root.

If the X– and Y–register values aren't close together, or the Z–register value isn't close to zero, the estimate from the X–register probably isn't a root.

If the X– and Y–register values are close together, and the Z–register value is close to zero, the estimate from the X–register may be an approximation to a root.

Interrupting a SOLVE Calculation

To halt a calculation, press or , and the message “” will be shown. The current best estimate of the root is in the unknown variable; use

to view it without disturbing the stack, but solving cannot be resumed.

Choosing Initial Guesses for SOLVE

The two initial guesses come from:

The number currently stored in the unknown variable.

The number in the X–register (the display).

7-8Solving Equations

Page 130
Image 130
HP 35s Scientific manual Interrupting a Solve Calculation, Choosing Initial Guesses for Solve, 8Solving Equations