HP 7200 manual Wireless network settings

Set up your network

Chapter 13

(continued)
Parameter	Description
Admin	Status of the administrator's password for the Embedded Web
Password	Server:
	● Set: password is specified. You must enter the password to
	make changes to the Embedded Web Server parameters.
	● Not Set: no password is set. A password is not required for
	making changes to the Embedded Web Server parameters.

Link Configuration

The speed at which data is transmitted over a network:

●10TX-Full: for wired network.

●10TX-Half: for wired network.

●100TX-Full: for wired network.

●100TX-Half: for wired network.

●None: networking is disabled.

Wireless network settings

The following table describes the wireless network settings shown on the network configuration page.

Parameter	Description
Wireless	Status of the wireless network:
Status	● Connected: the HP All-in-One is connected to a wireless LAN
	and everything is working.
	● Disconnected: the HP All-in-One is not connected to the
	wireless LAN due to incorrect settings (such as the wrong
	WEP key), or the HP All-in-One is out of range.
	● Disabled: either the radio is turned off, or the Ethernet cable
	is plugged in.
	● Not applicable: this parameter does not apply to this network
	type.
Communicatio	An IEEE 802.11 networking framework in which devices or
n Mode	stations communicate with each other:
	● Infrastructure: the HP All-in-One communicates with other
	network devices through a wireless access point, such as a
	wireless router or base station.
	● ad hoc: the HP All-in-One communicates directly with each
	device on the network. No wireless access point is used. This
	is also called a peer-to-peer network. On Macintosh networks,
	ad hoc mode is called computer-to-computer mode.
	● Not applicable: this parameter does not apply to this network
	type.
Network	Service Set Identifier. A unique identifier (up to 32 characters) that
Name (SSID)	differentiates one wireless local area network (WLAN) from

144 HP Officejet 7200 All-in-One series