Installing a New Display Assembly
When installing a new display, you must make sure to set the DIP switches on the video PCA to match the particular display assembly. Do this as follows.
Caution
Setting the DIP switches improperly could damage the display assembly.
1.Find the manufacturer of the display: this is shown on a label attached to the display assembly.
2.Find the display’s manufacturer and model in the table below, and set the DIP switches on the video PCA as shown.
Model | 1 | 2 | 3 | 4 |
CPT | ON | OFF | ON | OFF |
Hitachi | OFF | ON | OFF | OFF |
LG | ON | OFF | OFF | ON |
LG | OFF | ON | OFF | ON |
LG | ON | ON | ON | OFF |
Mitsubishi | ON | OFF | ON | ON |
Samsung | ON | ON | OFF | OFF |
Samsung | OFF | ON | ON | OFF |
Sanyo | OFF | OFF | ON | ON |
Unipac | OFF | OFF | ON | OFF |
Unipac | OFF | OFF | OFF | ON |
As an example, the following figure shows the DIP switches set to
1 2 3 4
O F F
Figure
HP OmniBook XE3 | Removal and Replacement |