4.Remove the retaining screws from the back of the notebook, just below the display hinges.

5.Remove both retaining screws from the hinge saddle set.

6.Lift the hinge saddle set out of the notebook. You may need to free the hinge saddle from the clip in the bottom case near the LAN/modem ports to remove it.

Screws,

M2.5x8 mm

Screws,

M2.5x8 mm

Figure 2-18. Removing the Hinge Saddle

Reassembly Notes

Make sure the posts on the underside of the hinge saddle line up with the hinge support openings in the bottom case, and that the holes in the front ends of the saddle fit over the alignment posts in the bottom case.

2-24 Removal and Replacement

HP OmniBook XE3

Page 52
Image 52
HP BOOK XE3 manual Removing the Hinge Saddle Reassembly Notes