HP CP4525DN Laser CC494A#ABA manual Remove the laser/scanner assembly C/Bk

Remove the laser/scanner assembly (C/Bk)

NOTE: After installing a new laser/scanner assembly, be sure to calibrate the product. See Calibrate the product on page 313.

1.Release one spring (callout 1), and then disconnect one FFC (callout 2).

CAUTION: The spring is not captive. Do not lose the spring when it is removed. Use a pair of needle-nose pliers to safely retain the spring when it is removed. Do not use a flat blade screwdriver to remove the spring; the spring could forcibly leave the product and strike you.

Reinstallation tip When you reinstall the spring, make sure that the laser/scanner fits tightly up against the product chassis, and make sure that the FFC is fully seated in the connector. The locator tabs on the front of the scanner must be firmly seated in the slots in the chassis.

Figure 2-180Remove the laser/scanner assembly (C/Bk) (1 of 5)

1

2

2.Disconnect one connector.

Figure 2-181Remove the laser/scanner assembly (C/Bk) (2 of 5)

ENWW Internal assemblies 191