HP CP4525DN Laser CC494A#ABA manual Description Recommended action, 59.F0 Error

Table 3-14Control-panel messages (continued)

Description	Recommended action
59.F0 ERROR	Transfer alienation failure	1.	Verify that the ITB is installed.
		2.	Reconnect the primary-transfer
			disengagement sensor J19, and
			connector J128 on the DC controller
			PCA .
		3.	Run the sensor test in the sensor
			monitor mode to verify that the primary
			transfer disengagement sensor is
			functioning properly. If not, replace the
			primary transfer disengagement sensor.
		4.	Perform the alienation drive component
			test in the DIAGNOSTICS menu. If not,
			replace the fuser motor. See Fuser
			motor on page 200.

60.02 ERROR Tray 2 is not lifting correctly.

1.Reconnect connector J115 on the DC controller PCA and the intermediate connector J58.

2.Run the sensor test in sensor monitor mode to verify that the cassette media stack surface sensor is functioning properly. If it is not, replace the pickup assembly. See Tray-pickup drive assembly on page 178.

3. Reconnect connector J56 of the lifter motor. Also check J107 on the DC controller PCA.

4. If the message persists, replace the lifter drive assembly. See Lifter-drive assembly on page 173.

60.03 ERRORTray 3 is not lifting correctly.1. Reconnect connector J408 on the paper deck controller PCA and the intermediate connector J11.

2. Run the sensor test in sensor monitor mode to verify that the cassette media stack surface sensor is functioning properly. If it is not, replace the pickup assembly. See Pickup assembly (optional paper feeder) on page 226.

3. Reconnect connector J15 of the lifter motor. Also check J407 on the paper deck controller PCA.

4. If the message persists, replace the lifter drive assembly. See Lifter-drive assembly (optional paper feeder)

on page 230.

354 Chapter 3 Solve problems ENWW