HP CP4525DN Laser CC494A#ABA manual Values, No System, Permanent Storage Full

Table 3-14Control-panel messages (continued)

Description	Recommended action
60.04 ERROR	Tray 4 is not lifting correctly.	1.	Reconnect connector J406 on the paper
			deck controller PCA and the
			intermediate connector J21.
		2.	Run the sensor test in sensor monitor
			mode to verify that the cassette media
			stack surface sensor is functioning
			properly. If it is not, replace the pickup
			assembly. See Pickup assembly
			(optional paper feeder) on page 226.
		3.	Reconnect connector J24 of the lifter
			motor. Also check J405 on the paper
			deck controller PCA.
		4.	If the message persists, replace the lifter
			drive assembly. See Lifter-drive
			assembly (optional paper feeder)
			on page 230.
60.05 ERROR	Tray 5 is not lifting correctly.	1.	Reconnect the connector J403 on the
			paper deck controller PCA and the
			intermediate connector J31.
		2.	Run the sensor test in the sensor
			monitor mode to verify that the PD
			cassette media stack surface sensor is
			functioning properly. If it is not, replace
			the middle pickup assembly. See Pickup
			assembly (optional paper feeder)
			on page 226.
		3.	Reconnect the connector J34 of the lifter
			motor and the connector. Also check
			J402 on the paper deck controller PCA.
		4.	If the message persists, replace the lifter
			drive assembly. See Lifter-drive
			assembly (optional paper feeder)
			on page 230.
62 NO SYSTEM	The product has an internal problem.	Turn the product off and then on.
To continue turn off then on
68.X PERMANENT STORAGE FULL	The product NVRAM is full. Some settings	Press the OK button to clear the message. If
To continue press OK	saved in the NVRAM might have been reset	the message is not cleared, turn the product
	to the factory defaults. Printing can continue,	off, and then turn the product on.
	but some unexpected functions might occur
	if an error occurred in permanent storage.

X values

●0 = Internal memory

●1 = Removable disk

ENWW Tools for troubleshooting 355