HP CP4525DN Laser CC494A#ABA Snmp Test YES, Data Path Test YES, Select ALL YES, Tests, Ping Test

Table 3-13Embedded Jetdirect menu (continued)

Item	Sub-item	Sub-item	Sub-item	Description
		SNMP TEST	YES	This test checks operation of SNMP
			NO*	communications by accessing predefined
				SNMP objects on the product.
				Select YES to choose this test, or NO to not
				choose it.
		DATA PATH TEST	YES	This test helps to identify data path and
			NO*	corruption problems on an HP postscript level
				3 emulation product. It sends a predefined PS
				file to the product, However, the test is
				paperless; the file will not print.
				Select YES to choose this test, or NO to not
				choose it.
		SELECT ALL	YES	Use this item to select all available embedded
		TESTS	NO*	tests.
				Select YES to choose all tests. Select NO to
				select individual tests.
		EXECUTION TIME		Use this item to specify the length of time (in
		[H]		hours) that an embedded test will be run. You
				can select a value from 0 to 24 hours. If you
				select zero (0), the test runs indefinitely until
				an error occurs or the product is turned off.
				Data gathered from the HTTP, SNMP, and
				Data Path tests is printed after the tests have
				completed.
		EXECUTE	YES	NO: Do not initiate the selected tests.
			NO*	YES: Initiate the selected tests.
	PING TEST			This test is used to check network
				communications. This test sends link-level
				packets to a remote network host, then waits
				for an appropriate response. To run a ping
				test, set the following items:
		DEST TYPE	IPV4	Specify whether the target product is an IPv4
			IPV6	or IPv6 node.
		DEST IPV4		Type the IPv4 address.
		DEST IPV6		Type the IPv6 address.
		PACKET SIZE		Specify the size of each packet, in bytes, to
				be sent to the remote host. The minimum is
				64 (default) and the maximum is 2048.
		TIMEOUT		Specify the length of time, in seconds, to wait
				for a response from the remote host. The
				default is 1 and the maximum is 100.
		COUNT		Specify the number of ping test packets to
				send for this test. Select a value from 0 to 100.
				The default is 4. To configure the test to run
				continuously, select 0.

ENWW Tools for troubleshooting 339