HP CP4525DN Laser CC494A#ABA Card Slot Device Failure, Card Slot File Operation Failed, Available

Table 3-14Control-panel messages (continued)

Description	Recommended action
CARD SLOT DEVICE FAILURE	The specified device has failed.	Press the OK button to clear.
To clear press OK
CARD SLOT FILE OPERATION FAILED	A PJL file system command attempted to	Press the OK button to clear.
To clear press OK	perform an illogical operation.
CARD SLOT FILE SYSTEM IS FULL	A PJL file system command could not store	Press the OK button to clear.
To clear press OK	something on the file system because the file
	system was full.
CARD SLOT IS WRITE PROTECTED	The file system device is protected and no	Press the OK button to clear.
To clear press OK	new files can be written to it.
CARD SLOT NOT INITIALIZED	This file-storage component must be	Use the embedded Web server or HP Web
	initialized before use.	Jetadmin to initialize the component.
CHECKING PAPER PATH	The product is checking for possible paper	No action is necessary.
	jams.
CHECKING PRINTER	The product is conducting an internal test.	No action is necessary.
CHOSEN PERSONALITY NOT	A print job requested a product language	Print the job by using a printer driver for a
AVAILABLE	(personality) that is not available for this	different printer language, or add the
To continue press OK	product. The job will not print and will be	requested language to the product (if
	cleared from memory.	possible). To see a list of available
		personalities, print a configuration page. (See
		Configuration page on page 307.)
CLEANING DISK <X>% COMPLETE	The product is cleaning the hard disk or a	Do not turn off. The product will automatically
Do not power off	compact flash disk.	restart when cleaning is complete. Product
		functions are unavailable.
CLEANING...	The product is performing an automatic	No action is necessary.
	cleaning cycle. Printing will continue after the
	cleaning is complete.
CLEARING EVENT LOG	This message is displayed while the event log	No action is necessary.
	is cleared. The product will exit the menus
	once the event log has been cleared.
CLEARING PAPER PATH	The product is attempting to eject jammed	Check progress at the bottom of the display.
	paper.
CLOSE FRONT DOOR	The front door of the product is open.	1.	Close the door.
		2.	Run the switch test in the sensor monitor
			mode to verify that the front-door switch
			is functioning properly.
		3.	Reconnect connector J45 on the front
			door switch and connector J129 on the
			DC controller PCA.
		4.	Check the sensor flag on the front-door
			assembly. If it is damaged, replace the

front-door assembly. See Front-door assembly on page 107.

358 Chapter 3 Solve problems ENWW