Chapter 9

c. If the jam is not there, push the latch on the top of the duplexer and lower its cover. If the jam is inside, carefully remove it. Close the cover.

d. Reinsert the duplexer into the printer.

3.Open the top cover and remove any debris.

4.If you have not found the jam and have Tray 2 installed, pull out the tray and remove the jammed media, if possible. If not, do the following:

a. Ensure the printer is turned off and disconnect the power cord. b. Lift the printer off Tray 2.

c. Remove the jammed media from the bottom of the printer or from Tray 2. d. Reposition the printer on top of Tray 2.

5.Open the print carriage access door. If there is paper remaining inside the printer, ensure the carriage has moved to the right of the printer, free any paper scraps or wrinkled media, and pull the media towards you through the top of the printer.

WARNING! Do not reach into the printer when it is on and the carriage is stuck. When you open the print carriage access door, the carriage should return to its position on the right side of the printer. If it does not move to the right, turn off the printer before you remove any jam.

6.After clearing the jam, close all covers, turn on the printer (if you turned it off) and resend the print job.

152 Solve a problem

Page 156
Image 156
HP Pro 8500A - A910a, Pro 8500A Plus - A910g, Pro 8500A Premium - A910n manual Chapter