HP Pro 8500A - A910a manual Test the wireless connection, Change the connection method

WPA2 is the second generation of WPA security; it provides enterprise and consumer Wi-Fi users with a high level of assurance that only authorized users can access their wireless networks.

•Data encryption:

ƕWired Equivalent Privacy (WEP) provides security by encrypting data sent over radio waves from one wireless device to another wireless device. Devices on a WEP-enabled network use WEP keys to encode data. If your network uses WEP, you must know the WEP key(s) it uses.

NOTE: Shared WEP key encryption is not supported.

ƕWPA uses the Temporal Key Integrity Protocol (TKIP) for encryption and employs 802.1X authentication with one of the standard Extensible Authentication Protocol (EAP) types available today.

ƕWPA2 provides a new encryption scheme, the Advanced Encryption Standard (AES). AES is defined in counter cipher-block chaining mode (CCM) and supports the Independent Basic Service Set (IBSS) to enable security between client workstations operating in ad hoc mode.

Test the wireless connection

Print the wireless test page for information about the printer's wireless connection. The wireless test page provides information about the printer's status, MAC address, and IP address. If the printer is connected to a network, the test page displays details about the network settings.

1.Touch right arrow , and then select Network.

2.Touch Wireless, and then select Wireless Network Test.

Change the connection method

If you have installed the HP software and connected your printer using a USB, Ethernet, or wireless connection, you can change to a different connection any time you want.

NOTE: If you are changing to a wireless connection, make sure that an Ethernet cable has not been connected to the printer. Connecting an Ethernet cable turns off the printer's wireless capabilities.

To change the connection method (Windows)

NOTE: If you are changing to a wireless connection, make sure that an Ethernet cable has not been connected to the printer. Connecting an Ethernet cable turns off the printer's wireless capabilities.

1.On the computer desktop, click Start, select Programs or All Programs, click HP, select your printer name, and then click Connect a New Printer.

2.Follow the onscreen instructions.

To change the connection method (Mac OS X)

1.Open the HP Utility. For more information, see HP Utility (Mac OS X).

2.Click the Application icon on the toolbar.

3.Double-click HP Setup Assistant, and then follow the onscreen instructions.

Guidelines for ensuring wireless network security

This section contains the following topics:

•To add hardware addresses to a WAP

•Other guidelines

Set up the printer for wireless communication 221