HP WP36/50 manual Hard Disk, Memory Card

Appendix A Option Units

2.4 Hard Disk

Insert the hard disk into its slot on the main circuit board of the printer. If a hard disk unit is installed in the printer, re- ceived data can be rasterized and stored on this hard disk. This enables high-speed printing of multiple copies using an electric sort function. Also, you can use the e-MPS functions. For details, see e-MPS on page 3-12.

For details on available hard disks, see your dealer.

1	Turn off the printer and disconnect the power cord
	and printer cable.
2
	Remove the two screws and remove the slot cover
	(HDD).

Figure A-8

3 Insert the optional hard disk unit into the slot.

	Figure A-9
4	Tighten the two screws to secure the hard disk unit
	to the main circuit board.

Figure A-10

2.5 Memory Card

Insert the memory card into the memory card slot located on the right side of the printer. A memory card is a microchip card that may contain option fonts, macros, forms, etc. The printer reads the contents of the card into its internal memo- ry when printer is turned on.

For details of available memory cards, see your dealer.

1 Turn off the printer.

NOTE

	Do not insert or remove a memory card while the
	power is on. If the memory card is removed while the
	printer is on, damage could result in the printer’s
	electronics or the memory card.
2
	Insert the memory card in the slot. Insert it with its
	label surface facing toward the outside, connector

end first. Push it in all the way.

Figure A-11

A-4