HP WP36/50 manual Installing DIMMs, Removing Dimm, Testing the Expansion Memory, DIMMs to be used

Appendix A Option Units

4.Installing DIMMs

■DIMMs to be used

See your Kyocera Mita dealer for purchasing information of the DIMMs that are best suited for use with this printer. 32 MB, 64 MB, 128 MB and 256 MB DIMMs can be used for memory expansion.

Insert the DIMM into the socket as shown below.

1	Remove the DIMM from its package.
2	Open the clips on both ends of the DIMM socket.
3	Insert the DIMM into the socket, so that the notches
	on the DIMM align with the corresponding protru-

sions in the socket.

Figure A-14

4	Close the clips of the DIMM socket to secure the
	DIMM.

Figure A-15

5	When you finish installing the DIMM, reinsert the
	main circuit board into the printer by reversing the

removal procedure.

4.1 Removing DIMM

To remove a DIMM, carefully pull the end clips outwards, then pull the DIMM out of the socket.

Return the main circuit board to the printer by reversing the procedure explained in Removing the Main Circuit Board from the Printer on page A-5.

Figure A-16

4.2 Testing the Expansion Memory

After you finish installing DIMMs in the printer, test the printer to see if the installation was successful. To test the ex- pansion memory, proceed as follows:

1	Make sure the printer is turned off. Plug the power
	cord into the printer and turn the printer on.
2
	Press the MENU key on the operator panel.
3	Press the	or	key repeatedly until Print
	Status Page appears.
4
	Press the ENTER key twice.
5	If the installation was successful, the amount of
	memory shown on the status page will correspond

with the amount of expanded memory. (The factory installed memory size is 32 MB for FS-9120DN, 64 MB for FS-9520DN.)

A-6