HP WP36/50 2.2 Using the Menu Selection System, 2.2.1 Printing the Menu Map, 2.2.2 Printing Status Page, MENU MAP, STATUS PAGE

Chapter 3 Using the Operator Panel

2.2 Using the Menu Selection System

This section explains the procedure for using the menu selection system. The menu selection system is activated by the MENU key while the printer is Ready.

2.2.1 Printing the Menu Map

The printer prints a full list of menu selections. Note that menus indicated on the list may vary depending on which option units are installed on the printer.

1	Press the MENU key.
2	Press the	or key repeatedly until Print Menu
	Map appears.
	Print
	Menu	Map
3	Press the ENTER key. A question mark (?) appears.
	Print
	Menu	Map ?
4	Press the ENTER key again. The printer prints a
	menu map.

MENU MAP

Figure 3-2

2.2.2 Printing Status Page

If you want to check the printer’s current status, including memory available and option settings, you can find the information you need on the status page.

1	Press the MENU key.
2	Press the	or	key repeatedly until Print
	Status Page appears.
	Print
	Status Page
3	Press the ENTER key. A question mark (?) appears.
	Print
	Status Page		?
4	Press the ENTER key again. The printer prints a
	status page.

NOTE

For a full description of the status, see the following sample status page.

The following is a sample status page. The numbers below refer to the contents explained on the next page.

	STATUS PAGE		1
	Firmware Version:	Released:
Hardware Information	Memory
2			3
Page Information	Installed Options
4			5
Network Status	Emulation
			7
6
	Error Log		8
	Toner Gauge
			9
	0		100

Interfaces

0

KIR Test pattern ON A

Figure 3-3

When the Network Status is turned on, the Network Interface Status Page will be printed after the Printer Status. (See page 3-20.)

3-11