Check Procedures 69
006 - ARE THE VOLTAGES CORRECT AND DOES
THE FAN RUN? (YES, READ AHEAD. NO, GO TO
STEP 009.)
•The power supply is working normally.
•If you suspect the on/off switch cable assembly,
see Step 003.
•If the fan continues to run when all connectors are
plugged back in, go to See “Undetermined
Problems” on page 72.
• If the fan stops running when a drive connector is
plugged back in, go to “Start” on page 31.
007 - DO YOU HAVE AN OHM READING WHEN
THE SWITCH IS PRESSED AND AN OPEN
READING WHEN THE SWITCH IS RELEASED?
(YES, READ AHEAD. NO, GO TO STEP 008.)
• Replace the on/off switch cable assembly.
008 -
• Replace the system board.
• End.
009 -
• Replace the power supply.
• End.
20-pin power connector
IDE power connector LS120 power connector