E-79
OTHERS
Warning display
When an error occurs, BR-HD50 automatically self-diagnoses the cause and displays an error-coded
warning message on the monitor.
If BR-HD50 is not in good order, or if an operation error has occurred, an alarm display will be shown on
the monitor.
ξ‚„Alarm display (Displayed regardless of the DISPLAY mode)
β€’ For alarm displays resulting from operation errors, refer to page 24.
3DNIV2KCH–1/2 6PSM0
W
ARNING 7001
DRUM MOTOR FAI LURE
06/14 / 05 STANDBY
-
OFF
11:20:00 TCR 02:00:00:0
0
3MINDV 2K CH–1 /2 SP 60
HEAD CLEANI NG REQUI RED !
06/10 / 05 STANDBY
-
OFF
11:20:00 TCR 02:00:00:00
Alarm displayWarning display
Display Status Action
LOW VOLTAGE The DC power voltage is low.
BR-HD50 will eventually go into the OPERATE
OFF mode if operation is continued.
Check the power voltage.
HEAD CLEANING
REQUIRED!
The video head is dirty. (This message is dis-
played when the DISPLAY mode is ON or
AUTO.) If the head is clogged, it will be
detected and the alarm message will be dis-
played in the PLAYBACK mode. The display
disappears when the cassette is ejected or the
head gets cleared of clog.
The message will also disappear when the
head cleaning tape is loaded.
Clean it with a JVC head-
cleaning tape. (XPage9)
If the message persists
despite cleaning, it could be
due to bad recording condi-
tion, defective tape or head
lifespan.
OVER HEATING! The internal temperature of BR-HD50 has
exceeded the stated value.
Disconnect the power and
place BR-HD50 in a cool
place. If this message is dis-
played again, the unit may
have been damaged. In such
a case, consult your JVC
authorized dealer.
UNPLUG MAIN
POWER, PLUG
BACK IN AFTER A
WHILE
This is a system error that occurs when the
power is turned on. The OPERATE indicator on
BR-HD50 blinks in green. The unit will not
accept any operation commands.
Unplug the power cord from
the power outlet and wait for
some time before plugging it
back in.