Menu Operations
Getting Information
You can get information on the input signal, accumulated used hours of
1Press the MENU button.
The main menu appears on the screen.
2 Select “Information” with the cursor button5 or ∞.
The “Information” will be displayed in the main menu. *No submenu can be selected.
Replacing the Fuse
A fuse is used to protect the power source of the projector. If the fuse is blown, replace it. When the power switch is turned | on |
but no power is supplied to the projector, check the fuse. If there are any unclear points, contact the dealer where you |
|
purchased your projector, or consult the Service center. |
|
CAUTION
•When replacing the fuse, use the same rating and type (12 A 250 V). Otherwise, a fire may occur and/or the projector may be damaged.
1Turn off the main power switch and disconnect the power cord from both
the projector and the wall outlet.
In
Video main menu
PC main menu
place the MAIN POWER switch of OFF [ ] position.
Menu
Image adj. Setting Color temp. Options Language
Information
Input | VIDEO |
Switcher | CH.0 |
Source | NTSC |
Lamp time | 123 h |
Menu
Image adj. Setting Color temp. Options Language
Information
Input |
| PC 1 |
Switcher |
| CH.0 |
Resolution | 1280 | 1024 |
Frequency H | 79.9kHz | |
Frequency V | 75 Hz | |
Lamp time | 123 | h |
2Loosen the fuse holder to remove it.
To loosen the fuse holder, use a Phillips screwdriver.
Fuse holder
No.51931
Input: | Shows the terminal name selected by the VIDEO or PC button. (Y/C, VIDEO or COMP, or PC1, PC2 or DVI) |
Switcher: | This display currently has no meaning. This is reserved for future use. (“CH.0” is usually displayed to |
| indicate that it is not being used.) |
Source: | Shows the projected image’s type of video signal. (Video menu mode) |
Resolution: | Shows the resolution of the video signal being received. (PC menu mode) |
| It may not be displayed correctly with some input signals. |
Frequency H: | Shows the horizontal frequency of the video signal being received. (PC menu mode) |
Frequency V: | Shows the vertical frequency of the video signal being received. (PC menu mode) |
Lamp time: | Accumulated used hours of the |
3Press the MENU button to exit the menu mode.
3Remove the fuse from the fuse holder you just removed.
4Install the new fuse (not supplied) into the fuse holder.
5Reinstall the fuse holder into the
projector.
To reinstall the fuse holder, use a Phillips screwdriver.
Phillips screwdriver
Fuse (12 A, 250 V)
Fuse holder
Fuse (12 A, 250 V)
Fuse holder
ESPAÑOLITALIANO FRANÇAISDEUTSHENGLISH
DLA- DLA-
1-29
56
57
G150CLU G150CLE