JVC DLA-G150CLE 1-72, Turn on the MAIN POWER switch to go, into stand-by mode, No.51931, Cautions

1-72

	Replacing the Light-Source Lamp
3 Insert the new light-source lamp fully	Light-source lamp
inside and fasten the screws.
Fasten the two screws with a flat-end screwdriver.

Replacing the Light-Source Lamp

■Resetting the Lamp Use Time

After replacing with a new light-source lamp, reset the lamp-time counter inside the projector to clear the accumulated lamp time to zero (0). After resetting, a new count will start for the new light-source lamp.

DLA-G150CLU DLA-G150CLE

CAUTION

■ Projector’s button

1Turn on the MAIN POWER switch to go

• Do not touch the glass surface of the light-source lamp

directly with your hand as well as staining it. If you touch

with a bare hand, oils and other substances on your hand

STAND BY indicator

into stand-by mode.

In stand-by mode, the STAND BY indicator on the projector lights up.

may adhere to the lamp, possibly preventing it from
performing as specified and therefore giving a shortened
lamp life, a darkened screen, etc. To handle a new light-
source lamp, hold it by the plastic part. Never touch the	Handle
metal part or the front glass surface.

4Replace the lamp-replacement opening

cover and fasten the screws.

Fasten the two screws with a flat-end screwdriver.

CAUTIONS

• Install the light-source lamp and close the lamp- replacement opening cover correctly; otherwise, a safety

Screw

Lamp-replacement opening cover

4HIDE button

3EXIT button

STAND BY

LAMP TEMP

	OPERATE
	HIDE
	PC
KEYSTONE
	VIDEO
PRESET	MENU
EXIT	ENTER

Cursor buttons 5/∞

OPERATE indicator

1PC button

MENU button

2ENTER button

2Press the following buttons on the projector, sequentially.

1Momentary press the PC button.

2Momentary press the ENTER button.

3Momentary press the EXIT button.

4Press and hold the HIDE button for two seconds

or more.

* During this sequence, the STAND BY and OPERATE

indicators alternately blink about every approx. 3 seconds. After completion of the sequence, the STAND BY indicator alone stays on.

*Buttons must be pressed within 2 seconds of the previous button.

*When you make a mistake in button operations, return to the beginning of the sequence.

*To check the lamp time on the menu, press the MENU button

and select “Information” with the cursor button 5 or∞. The lamp use time is indicated in the item “Lamp time”.

No.51931

switch is activated to prevent the projector from operating.

• If the claw on the lamp-replacement opening cover is damaged, the projector may not possibly operate. Then, replace with a new lamp-replacement opening cover.

5Reset the lamp use time.

Perform “Resetting the Lamp Use Time” on page 62.

Be careful not to damage the claw.

FRANÇAISDEUTSHENGLISH

Video main		menu
	Menu
	Image adj.	Input	VIDEO
	Setting	Switcher		CH.0
	Color temp.	Source	NTSC
	Options
	Language
		Lamp time		123 h
	Information
PC main menu
	Menu
	Image adj.	Input		PC 1
	Setting	Switcher		CH.0
	Color temp.	Resolution	1280	1024
	Options	Frequency H	79.9kHz
	Language	Frequency V	75 Hz
		Lamp time	123	h
	Information

Lamp time (0 h)

Lamp time (0 h)

ESPAÑOLITALIANO

CAUTION

• Reset the lamp use time only when you have replaced with a new light-source lamp. Never reset it during lamp life, otherwise the replacement time may become unclear, and lead to degraded performance or lamp explosion.

61

62