1-56
Connecting to Various Devices
Connecting to DVI
Before connection, be sure to turn off both the projector and computer devices.
• Read thoroughly the manual that comes with each device.
Connecting to Various Devices
Connecting | the Power Cord |
|
|
After all devices have been finished being connected, connect the supplied power cord. At this time, | do | not yet turn on the | |
MAIN POWER switch | . |
|
|
| 1 Insert the supplied power cord into the | ||
| power input terminal | of | the projector. |
DOS/V
(DVI VIDEO BOARD)
DVI
IN
R
G
B
H
V
P
P
| Ferrite core |
2 Insert the | main plug of the supplied |
power cord | into a suitable wall outlet. |
Power cord (supplied)
No.51931
IN
Note
• Other connections are the same as in the connection example for IBM PC or IBM compatible PCs.
How to attach the ferrite core
Attach the ferrite core when using the
1Release the stopper at each end and
open the ferrite core.
ENGLISH
for European continent countries
for United Kingdom
CAUTIONS
To prevent fire and electric shock, observe the following:
• When you do not use devices, pull out their power cords |
from wall outlets. |
• Do not connect the devices with power cords other than |
for European | for United Kingdom |
continent countries |
|
Note
• The power cord for the United Kingdom is only included as
a special accessory when shipped to the United Kingdom . It is not included when shipped to European continent
countries.
CAUTIONS
• Since the power requirement of the projector is high, insert |
the power plug directly into a wall outlet. |
• Use the supplied power cord with the ferrite core only. |
• Do not remove the ferrite core from the supplied power |
2Wind the cord around the ferrite core.
Attach the ferrite core about 3 cm from the end of the cord.
Stoppers
Wind the cable once.
DEUTSH
those supplied. |
• Do not use mains voltage other than the power voltage |
indicated. |
• Do not scar, damage, or work on the power cords. Also, do |
not put a heavy object on, heat, or stretch the power cords, |
otherwise they may be damaged. |
• Do not insert or pull out the plugs with a wet hand. |
cord; Otherwise, there may be a possibility that a harmful |
interference occurs. |
3Close the ferrite core with the cord inside until you hear it click shut.
Note
•When connecting, connect the terminal which is at the ferrite core end of the cord to the projector.
Click!
ESPAÑOLITALIANO FRANÇAIS
Removing the Lens Cap
Remove the lens cap before using the projector.
Notes
•The lens cap is supplied with the lens unit (optional). It should be attached to the lens when the projector is not used.
•Do not operate the projector with the lens cap attached. Doing so can deform the lens cap because of the heat. A metallic lens cap can get hot and cause injury.
29
30