JVC DLA-G150CLE Installing the Projector, Installing Batteries, Precautions for Installation

1-8

Controls and Features

Installing Batteries

Install batteries in the remote control. If the remote control has started to work erratically, replace the batteries.

Installing the Projector

Precautions for Installation

CAUTIONS

DLA-G150CLU DLA-G150CLE

No.

1Open the back cover.

Open the back cover in the direction of the arrow.

2Install the batteries.

Place the two supplied batteries (AA/R6-size) in the remote control as illustrated below.

Precautions for using batteries

If batteries are used incorrectly, they may crack or leak liquid. This could cause a fire, burn, malfunction, or staining or damaging of the surroundings.

Beware of the following:

•Do not mix new and old batteries.

•Do not mix different types of batteries as they differ in characteristics.

•Place batteries so they match the polarities indicated:

(+)to (+) and (–) to (–).

•Be sure to put the minus (–) end in first to avoid

short-circulating.

•Use only designated batteries.

•Remove the batteries if the remote is not to be used for a prolonged period.

•When the batteries are exhausted, replace them

immediately. Otherwise, liquid could leak, or malfunction could occur due to leaking liquid. If the leaked liquid

contacts the skin, wipe it off with a cloth, otherwise the skin could become rough.

•Do not put batteries into a fire or try to recharge them.

•Batteries run for six months to one year in normal use. However, the batteries supplied are for confirming operation and may not run that long. When the remote

control starts failing to work properly, replace the batteries with new ones.

1.Before installation, do not connect the projector’s power cord.

2.Do not install the projector in the following places:

•Where there is water, humidity or dust.

•Where the projector may be subjected to oil, smoke or cigarette smoke.

•On a soft surface such as a carpet or cushion.

•Where the projector may be subjected to direct sunlight.

•Where temperature is high or humidity is low.

Allowable operation temperature range: 41°F to 95°F (+5°C to +35°C)

Allowable relative humidity range: 20% to 80% (no condensation)

Allowable storage temperature range: 14°F to 140°F (–10°C to +60°C)

■When installing the projector, observe the following:

• Do not use the projector placed on its side.

Avoid using the projector placed on its side. This could cause a malfunction.

• Use the projector within the specified angle.

Do not use the projector inclined ±30° horizontally (left/right). This could cause color variation or shorten the lamp life.

• Do not block the exhaust vents.

Do not use a cover which encloses the projector air-tight or blocks the exhaust vents. Allow sufficient space around the projector. When the projector is enclosed in a space of the following dimensions, use an air conditioner so the temperature inside becomes equal to the outside temperature.

Allowable minimum space required

	300mm
200mm	600mm

51931

3Close the back cover.

First fit the claws on the back cover in the case, then close the back cover in the direction of the arrow.

14

300mm

200mm

ESPAÑOLITALIANO FRANÇAISDEUTSHENGLISH

15