Controls and Features
Front Side / Top Surface / Right Side
1
9
8
7
6 | 5 4 3 2 |
Left-hand Side / Rear Side
| DLA | DLA |
Controls and Features | ||
|
|
No.51931
1Exhaust vents
Vents for cooling fans through which warm air comes out.
CAUTION
•Do not block the exhaust vents, or heat will build up inside, possibly causing a fire. Also, do not touch the vents, or this could give you a
2Carrying handle
Raise this handle when carrying the projector.
CAUTIONS
•When carrying the projector, do not transmit shocks to it. Also be careful to keep it balanced.
•Do not carry it while the
3AC IN (power input) terminal
This is the power input terminal where the supplied power cord is connected. For details, refer to page 30.
4Fuse holder
A fuse rated 12A/250V is installed. (Power source protection)
To replace the fuse, refer to page 57.
CAUTION
•When replacing the fuse, use the same rating and type. Otherwise, a fire may occur and/or the projector may be damaged.
5 MAIN POWER switch
6Adjustable feet (for adjusting the height and angle)
By extending the feet, the projector angle can be adjusted up to +7°.
For details, refer to “Adjusting the Inclination of the Projector” on page 16.
7Lens
One of the optional lens units should be installed before using the projector.
A
For details on the types of optional lenses available, refer to page 18.
CAUTION
•Please consult your authorized dealer or service center for information about attaching an optional lens.
8Lens cap
This is the lens cap provided for the optional lens.
When you are not using the projector, attach the lens cap to protect the lens from dirt or being damaged. (Refer to page 30.)
9Remote sensor
When operating with the remote control, aim it toward this sensor. (Refer to page 20.)
pConnector panel
For details, refer to “Connector Panel” on page 11.
qRear adjustable foot (for leveling the projector) It is set at the shortest position when shipped from the factory. Turn the foot to make the projector level. Adjustment can be made in the range of +1.5° and
from the horizontal position. For details, refer to “Adjusting the Inclination of the Projector” on page 16.
wAir inlet
This is the air inlet. Do not cover or obstruct this slot.
eControl panel
For details, refer to “Control Panel on the Projector” on page 9.
rLens shift knob cap
When you have mounted a lens that uses the lens shift function, open this cap and rotate the lens shift knob to move the lens position. For more information, refer to “Setting the Amount of Lens Shifting” on page 19.
FRANÇAISDEUTSHENGLISH
This is the main power switch. When it is turned on, the projector goes into
ON [ ]:The main power turns on.
OFF [ ‡]:The main power turns off.
6
ESPAÑOLITALIANO
7