Filename [DR-MV1SEK_04Name.fm]

 

DR-MV1SEK_00.book Page 18 Thursday, April 15, 2004 3:30 PM

Masterpage:Left0

 

18 EN INSTALLING YOUR NEW UNIT

1 Place the unit on a stable, horizontal surface.

Basic Connection2 Connect the unit to a TV depending on the TV and cables you use.

 

 

Basic Connection

 

Aerial connector

 

8 To connect to a TV with AV input connectors —

 

A Disconnect the TV aerial cable from the TV.

Back of TV

 

B Connect the TV aerial cable to the ANTENNA IN connector on

 

 

 

 

the rear panel of the unit.

 

 

 

C Connect the ANTENNA OUT connector on the rear panel of the

 

 

unit and the TV’s aerial connector with the provided RF cable.

 

 

D Connect the L-1 IN/OUT connector on the rear panel of the unit

RF cable

 

and the TV’s 21-pin SCART connector with a provided 21-pin

TV aerial cable

SCART cable.

 

(provided)

The L-1 IN/OUT connector accepts and delivers either a composite

 

 

 

signal (regular video signal), Y/C signal or RGB signal.

 

 

Set your TV to the VIDEO (or AV), Y/C, or RGB mode according to

 

 

the type of your TV’s SCART connector.

 

 

Select an appropriate option of “L-1 OUTPUT” as follows ( pg. 74):

21-pin SCART connector

 

When your TV’s SCART

 

21-pin SCART cable

 

Set “L-1 OUTPUT” to:

 

connector accepts:

(provided)

 

 

 

 

 

 

 

Composite video signals

“SCART VIDEO”

 

 

Y/C signal (separated

 

 

 

luminance (brightness) and

“SCART S-VIDEO”

 

 

chrominance (colour) signals)

 

 

 

RGB signal

“SCART RGB”

Mains power cord

ANTENNA IN

2

 

Back of unit

Mains outlet

L-1 IN/OUT

 

ANTENNA OUT

It’s essential that your unit be properly connected.

ATTENTION:

Your TV must have a 21-pin AV input connector (SCART) for the connection to the unit.

THESE STEPS MUST BE COMPLETED BEFORE ANY VIDEO OPERATION CAN BE PERFORMED.

8Component Video Connection (DVD deck only)

To connect to TV’s component video input connectors

APerform A C in “Basic Connection”.

BConnect the unit’s COMPONENT VIDEO OUT connectors to the TV’s component video input connectors.

C Connect the unit’s AUDIO OUT connectors to the TV’s AUDIO input connectors.

You can obtain high-quality component video pictures.

If your TV is not stereo-capable, use the unit’s AUDIO OUT connectors to connect to an audio amplifier for Hi-Fi stereo sound reproduction.

By using the component video connection, you can view the images in the progressive mode. For switching to the progressive mode, refer to “Scan Mode Set” ( pg. 89).

3 Plug the end of the AC power cord into an AC outlet.

“LOADING” blinks on the front display panel when the AC plug of the power cord is connected into a mains outlet and no operation will be done for approximately 50 seconds. This is not a malfunction.

After connection is completed, perform “Auto Set Up” on page 19.

Page 18

April 15, 2004 3:19 pm

Page 18
Image 18
JVC DR-MV1B manual Basic Connection, To connect to a TV with AV input connectors, When your TV’s Scart, Set L-1 Output to