Filename [DR-MV1SEK_09Editing.fm]

 

DR-MV1SEK_00.book Page 79 Thursday, April 15, 2004 3:30 PM

Masterpage:Right+

 

 

SYSTEM CONNECTIONS EN 79

Connecting To A Dolby Digital Decoder

When you can’t switch the audio channel of a bilingual

programme

Or An Amplifier With Built-in DTS

When the unit is connected with a digital audio device using an

optional optical cable and “DIGITAL AUDIO OUT” is set to “DOLBY

 

DIGITAL/PCM”, it is not possible to switch the audio channel of a

These instructions enable you to connect your unit to a Dolby

bilingual programme recorded on a DVD-RAM or DVD-RW (VR

Digital decoder or an amplifier with built-in DTS.

mode) disc. In this case, perform the following steps using the

 

remote control to switch “DIGITAL AUDIO OUT” from “DOLBY

Dolby Digital Decoder or

DIGITAL/PCM” to “PCM ONLY”.

A Press SET UP to access the Main Menu screen.

amplifier with built-in DTS

B Press w e to select “DVD SET UP”, then press ENTER.

 

 

C Press w e to select “AUDIO OUTPUT”, then press ENTER.

 

D Press rt to select “DIGITAL AUDIO OUT”, then press

 

ENTER.

 

E Press rt to select “PCM ONLY”, then press ENTER.

 

( pg. 80)

 

F Press SET UP to complete the setting.

 

G Press AUDIO to select the desired audio channel. ( pg. 30)

To DIGITAL AUDIO input

Coaxial cable (not provided)

Optical cable (not provided)

DIGITAL AUDIO OUT (COAXIAL)

2

DIGITAL AUDIO OUT (OPTICAL)

Note for connection:

Remove the protection cap from the cable.

1 Connect the unit and a Dolby Digital decoder or an amplifier with built-in DTS using either an optional optical cable or an optional coaxial cable.

NOTES:

For Dolby Digital sound, set “DIGITAL AUDIO OUT” to “DOLBY DIGITAL/PCM”. ( pg. 80)

For DTS sound, set “DIGITAL AUDIO OUT” to “STREAM/PCM”. ( pg. 80)

CAUTIONS:

This unit has a dynamic range of more than 110 dB with regards to its Hi-Fi audio capability. It is recommended that you check the maximum level if you are going to listen to the Hi-Fi audio signals through a stereo amplifier. A sudden surge in the input level to the speakers may damage them.

Some speakers and televisions are specially shielded to prevent television interference. If both are of the non-shielded type, do not place the speakers adjacent to the TV set as this can adversely affect the playback picture.

Page 79

April 15, 2004 3:18 pm

Page 79
Image 79
JVC DR-MV1B manual When you can’t switch the audio channel of a bilingual, Programme