JVC DR-MV1B manual Auto Set Up, Number Set, Auto Channel Set/Auto Clock Set/Auto Guide Program

Filename [DR-MV1SEK_04Name.fm]
DR-MV1SEK_04Name.fm Page 19 Thursday, April 22, 2004 6:32 PM	Masterpage:Right0
	INITIAL SETTINGS EN 19

Auto Set Up			NOTES:
			● In areas where no TV station transmits a PDC (Programme Delivery
Auto Channel Set/Auto Clock Set/Auto Guide Program			Control) signal, the unit can perform neither Auto Clock Set nor Auto
			Guide Program Number Set.
Number Set			● If there is a power cut, or if you press 1 or SET UP while Auto Set
			Up is in progress, Auto Set Up will be interrupted; be sure to turn off
			the unit power once and try again from step 1.
After the 1 button on the unit or remote control is pressed for			● Auto Clock Set may not function properly depending on the reception
			condition.
the first time to turn on the unit, the Auto Set Up function sets the
tuner channels, clock and Guide Program numbers			After “Auto Set Up” is completed, perform “Monitor Set (DVD
automatically.			Deck Only)” on page 25.
VCR/DVD		SAT
1	2	3
4	5	6
7	8	9
	0

ENTER	rtw e
SET UP

Before starting, make sure of the following:

●The TV aerial cable should be connected to the unit.

●The unit’s mains power cord should be connected to a mains outlet.

●Turn on the TV and select the AV mode.

●Slide the TV/CABLE/SAT/DVD switch to DVD.

1 Press 1 to turn on the unit. The Country Set display appears on the TV screen. The AUTO SET/T-V LINK display appears on the TV screen.

2 Press rt to select “AUTO SET”, then press ENTER. The AUTO SET screen will appear, and the unit automatically performs Auto Channel Set.

●When Auto Channel Set is completed, “PLEASE WAIT” will

be displayed for about 90 seconds, since channel data is exchanged

between the DVD deck and the VHS deck. No operation will be done during this time.

ATTENTION:

●When you have connected the unit

to a TV offering T-V Link via a fully-wired 21-pin SCART cable ( pg. 18) and the TV is turned on, the unit automatically performs the Preset Download ( pg. 20) even if you select “AUTO SET” for Auto Set Up function.

ATTENTION:

Once you have performed Auto Set Up, even if the unit’s memory backup has expired, all the stored stations and their Guide Program numbers remain in the unit’s memory and the unit will not perform Auto Set Up again. The unit only performs Auto Clock Set when the unit is turned on.

If you have moved to a different area, perform each setting as required.

●Tuner setting ( pg. 83)

●Clock setting ( pg. 86)

If a new station starts broadcasting in your area, perform tuner setting. ( pg. 83)

Page 19

April 22, 2004 6:31 pm