JVC DR-MV1B Deck Only, Satellite Receiver Control Setting DVD, Installing Satellite Controller

Filename [DR-MV1SEK_04Name.fm]
DR-MV1SEK_00.book Page 23 Thursday, April 15, 2004 3:30 PM	Masterpage:Right+
	INITIAL SETTINGS EN 23

Satellite Receiver Control Setting (DVD	The following procedure is required if you receive satellite channels
	through a satellite receiver. Approximately 20 seconds before the
Deck Only)	VIDEO Plus+ Timer Programming ( pg. 45) or Manual Timer
	programming ( pg. 46) starts, the unit sets its input mode to “L-2”
	and automatically switches the satellite receiver’s channels using a
Satellite receiver	provided Satellite Controller.

Installing Satellite Controller

Your unit	Satellite Controller
	(provided)
	(suggested locations)
	Transmitter
	Satellite Controller
	(provided)

Satellite receiver

21-pin SCART cable (provided)

Back of unit

2

SAT CONTROL L-2 IN/DECODER

VCR/DVD		SAT
1	2	3
4	5	6
7	8	9
	0

ENTER	rtw e
SET UP

Page 23

1 Place a Satellite Controller so that the path between its transmitter and the satellite receiver’s remote sensor is unobstructed.

2Fix securely using the adhesive strip attached on the back of the Satellite Controller.

3Be sure to connect the unit’s L-2 IN/DECODER connector to the satellite receiver’s 21-pin SCART connector.

NOTE:

When connecting your satellite receiver, refer to its instruction manual.

4 Connect the Satellite Controller to the SAT CONTROL connector on the rear panel.

Setting Satellite Receiver’s Brand And Channel

After installation, set the satellite receiver’s brand and channel correctly; otherwise, the Satellite Controller cannot work correctly.

●Turn on the unit.

●Turn on the TV and select the AV mode.

●Slide the TV/CABLE/SAT/DVD switch to DVD.

1 Turn on the satellite receiver’s power.

2 Press SET UP to access the Main Menu screen.

3 Press w e to select “INITIAL SET UP”, then press ENTER.

4 Press w e to select “SAT/

GUIDE PR”, then press ENTER.

5 Press rt to select “SAT BRAND”, then press ENTER.

6 Press rt to select the brand code from the list on page 24, then press ENTER.

●If the brand code you entered is invalid, the code field will be reset. Enter the correct brand code again.

●If the unit is in playback or recording mode, you cannot set the brand code.

7 Press the appropriate number keys to enter one of the channel positions on the satellite receiver, then press ENTER twice. The unit enters the Test mode.

●You can select the channel position between 1 to 999.

CONTINUED ON NEXT PAGE

April 15, 2004 3:19 pm