JVC DR-MV1B Delete a Channel, Change Station Channel Position, Set Stations a, Set Stations B

Press w e to locate the character insertion point.

Press rt to select “ID”, then press ENTER.

Filename [DR-MV1SEK_10Subsidiary.fm]
DR-MV1SEK_00.book Page 85 Thursday, April 15, 2004 3:30 PM	Masterpage:Right+

SUBSIDIARY SETTINGS EN 85

Delete A Channel

1 Perform steps 1 and 3 of “Manual Channel Set” ( pg. 84) to access the Confirmation screen before continuing.

2 Press rt w e to select the item you want to delete.

3 Press & to delete a channel. The item next to the cancelled one moves up one line.

●Repeat steps 2 and 3 as necessary.

4 Press SET UP to close the Confirmation screen.

Change Station Channel Position

1 Perform steps 1 and 3 of “Manual Channel Set” ( pg. 84) to access the Confirmation screen before continuing.

2 Press rt w e to select the item you want to move, then press

ENTER.

3 Press rt w e to select the new channel position, then press

ENTER.

Example: If you moved the station in position 4 to position 2, the stations originally in positions 2 and 3 each move down one space.

●Repeat steps 2 and 3 as necessary.

4 Press SET UP twice to close the Confirmation screen.

Set Stations (A)

Set station names that are registered in your unit.

1 Perform steps 1 and 3 of “Manual Channel Set” ( pg. 84) to access the Confirmation screen before continuing.

2 Press rt w e to select the item you want.

3 Press ENTER twice to access the Manual Channel Set screen.

4

5 Press rt until the new station’s name (ID) you want to store appears, then press ENTER. Registered station names

( pg. 100) appear as you press rt.

6 Press w e to select “OK”, then press ENTER.

●Repeat steps 2 – 6 as necessary.

7 Press SET UP twice to close the Confirmation screen.

Set Stations (B)

Set station names other than the ones registered in your unit.

1 Perform steps 1 and 3 of “Manual Channel Set” ( pg. 84) to access the Confirmation screen and then perform steps 2 and 3 of “Set Stations (A)” above before continuing.

2 Press rt to select “ID”, then press ENTER.

3 Press ENTER twice.

4

5 Press rt to cycle through the characters (A–Z, 0–9, –, f, +, I (space)) and stop when the desired character is indicated, then press e to enter.

●Enter the remaining characters the same way (maximum of 4).

6 After entering all characters, press w e to select “OK”, then press ENTER.

7 Press SET UP twice to close the Confirmation screen.

NOTE:

The characters available for the station name (ID) are A–Z, 0–9, –, f, +, I (space) (maximum of 4).

Fine-Tuning Channels Already Stored

1 Perform steps 1 and 3 of “Manual Channel Set” ( pg. 84) to access the Confirmation screen before continuing.

2 Press rt w e to select the channel you want to fine-tune, then press ENTER.

3 Press ENTER twice.

4 Press ENTER to access the Manual Channel Set screen. The Manual Channel Set screen appears.

5 Press rt to select “FINE”.

6 Press w e until the picture appears in its best quality.

●Repeat steps 2 – 6 as necessary.

7 Press SET UP three times to close the Confirmation scree.

Page 85

April 15, 2004 3:21 pm