JVC DR-MV1B Tape Dubbing (From VCR To DVD)

Masterpage:Right0
EN 67
Filename [DR-MV1SEK_09Editing.fm]
Page 67 April 15, 2004 3:18 pm
EDITING
Dubbing An Entire Cassette
Because this unit includes both DVD deck and VCR deck, you can
easily use this unit for dubbing without connecting any other
equipment.
1For DVD deck
Load a recordable disc.
For VCR deck
Load a cassette you want to dub.
2Press VCR/DVD repeatedly so that the DVD lamp lights up on
the unit.
3Press REC MODE repeatedly to set the recording mode.
4Press VCR] to select the dubbing direction.
●“VCR]” lights up on the unit.
5Press and hold DUB for more than 2 seconds to start dubbing.
●If the tape has not been rewound, the VCR deck rewinds the tape
automatically. When the VCR deck has finished rewinding, dubbing
begins automatically.
●After dubbing is completed, the VCR deck rewinds the tape
automatically and the unit shuts off.
●To stop dubbing, press 8.
NOTES:
●If you set the dubbing direction incorrectly, you could erase an
important recording that you wanted to dub. It is recommended to
conduct a test with unimportant cassettes first.
●The superimposed indication during the operation or dubbing is not
recorded.
●It is not possible to dub a tape with a copy protection signal.
●If the recording capacity of disc become full, the tape stops
automatically.
●It is not possible to perform other operations like Live Memory
Playback. Check the recorded programme on the disc after dubbing.
●Dubbing is not possible on the discs used exclusively for On-Disc
Timer Programming.
●If the index code is found on a tape, a single title is created. While
creating a title, the dubbing stops and then starts again.
Tape Dubbing (From VCR To DVD)
●Turn on the unit.
●Turn on the TV and select the AV mode.
●Slide the TV/CABLE/SAT/DVD switch to DVD.
1
4
7
2
5
8
0
3
6
9
REC MODE
8
SAT
8
VCR ]
DUB
VCR/DVD
DR-MV1SEK_00.book Page 67 Thursday, April 15, 2004 3:30 PM