JVC DR-MV1B manual Adjusting The Picture Quality, Simulated Surround Effect

Filename [DR-MV1SEK_05DVD Operation1.fm]
DR-MV1SEK_00.book Page 38 Thursday, April 15, 2004 3:30 PM	Masterpage:Left+

38 EN OPERATIONS ON DVD DECK

a		Adjusting The Picture Quality
		SAT
1	2	3

4 5 6 0 – 9

7 8 9

CANCEL (&) 0

ON SCREEN

ENTER rtw e

26

4

CLEAR (8)

Simulated Surround Effect

It is possible to get a simulated surround effect from your stereo system. You can enjoy the virtual surround sound with your 2-channel stereo system.

1 Press ON SCREEN twice to access the on-screen bar.

2Press w e to select “ ”, then press ENTER.

●Above the selected item, “3D-ON” appears and Simulated Surround Effect is activated.

●Each time you press ENTER, “3D-ON” appears and disappears alternately.

To clear the on-screen bar

Press ON SCREEN.

To cancel the simulated surround effect

Press ENTER to clear “3D-ON” from the screen.

NOTES:

●The simulated surround effect works correctly only when playing back a title recorded in multichannels.

●Simulated Surround Effect does not affect the DVD VIDEO bitstream signal from the DIGITAL AUDIO OUTPUT connector.

●When Simulated Surround Effect is activated, the settings of “ANALOG AUDIO OUT” and “D. RANGE CONTROL” are disabled. ( pg. 80)

You can obtain optimal picture quality by selecting an appropriate picture mode.

1 Press ON SCREEN twice to access the on-screen bar.

2Press w e to select “”, then press ENTER. The pop-up window appears under the selected item.

3Press rt to select the desired option, then press ENTER.

NORMAL: Normally select this option.

CINEMA: Suitable for a movie disc, etc.

SHARP: Clearer, sharper-edged picture when viewing images with lots of flat, same-coloured surfaces such as cartoons.

SOFT: Select this option when too much noise appears.

To clear the on-screen bar

Press ON SCREEN.

Page 38

April 15, 2004 11:41 am