Masterpage:Right+
EN 73
Filename [DR-MV1SEK_09Editing.fm]
Page 73 April 15, 2004 3:18 pm
EDITING
You can use your unit as the source player or as the recording
deck.
NOTE:
When using another recorder as the recording deck, refer to its
instruction manual.
1Connect the player’s 21-pin SCART connector to the unit’s 21-
pin SCART connector as illustrated.
AWhen using your unit as the source player:
— connect its L-1 IN/OUT connector to the recording deck.
BWhen using your unit as the recording deck:
— connect its L-1 IN/OUT or L-2 IN/DECODER connector to
the source player.
●If another recorder is compatible with the Y/C signal (DVD deck only):
— when using your unit as the source player, set “L-1 OUTPUT” to
“SCART S-VIDEO”. (墌pg. 74)
— when using your unit as the recording deck, set “L-2 SELECT” to
“S-VIDEO”. (墌pg. 74)
2Press VCR/DVD repeatedly to select the recording deck.
3Press PR +/– to select “L-1” for the L-1 IN/OUT connector, or
“L-2” for the L-2 IN/DECODER connector, depending on the
connector being used when using this unit as the recording deck.
For DVD deck
●When using the L-1 IN/OUT connector, set “L-1 OUTPUT” to
“VIDEO” or “S-VIDEO”. (墌pg. 74)
●When using the L-2 IN/DECODER connector, set “L-2 SELECT” to
“VIDEO” or “S-VIDEO”. (墌pg. 74)
4Press REC MODE repeatedly to set the recording mode.
5Engage the Play mode of the source player.
6Engage the Record mode of the recording deck.
7Stop recording on the recording deck, then stop playback on the
source player.
NOTES:
●All necessary cables can be obtained from your dealer.
●For Y/C signal input/output, be sure to use a 21-pin SCART cable
that is compatible with the Y/C signal.
●When you use this unit as the source player for editing, be sure to set
“SUPERIMPOSE” or “O.S.D.” to “OFF” before starting. (墌pg. 81, 82)
●If you are using another recorder with S-Video and Audio output
connectors, connect its S-Video and Audio output connectors to this
unit’s S-VIDEO and AUDIO input connectors on the front panel.
Then, set the unit’s input mode to “F-1” in step 3, and set “F-1 INPUT”
to “S-VIDEO”. (墌pg. 75) (DVD deck only)
Edit To Or From Another Recorder
2
Player Your unit
Another recorder
Recorder
TV receiver
AWhen using your unit as the source player:
21-pin SCART cable
(not provided)
21-pin SCART cable
(provided)
Recorder Your unit
Another recorder
Player
TV receiver
BWhen using your unit as the recording deck:
21-pin SCART cable
(not provided)
21-pin SCART cable
(provided)
Slide the TV/CABLE/SAT/DVD switch to DVD.
DR-MV1SEK_00.book Page 73 Thursday, April 15, 2004 3:30 PM