JVC Model HR-DVS1U Check Program Data, Engage Timer Mode, EN41, Set Tape Speed, press STOP +

T	W			NUMBER	"9"
1	2	3
			2
4	5	6

NUMBER "8" 7		8	9
		0	TIMER
CANCEL			4
STOP+/–
PROG.	1	DV	VHS
			SP/EP
		3
OK

ATTENTION

If there is a conflict in the timer schedule and one program overlaps with another, only the parts shown below in gray will be recorded.

Pattern 1: The program with the lower program number will be recorded.

10:00	11:00	12:00
Program 1	CH10
Program 2			Not recorded
	CH40

Pattern 2: The program that is broadcast earlier will be recorded.

10:00	11:00	12:00
Program 1	CH10
Program 2			Not recorded
	CH40

Pattern 3: The program that is broadcast earlier will be recorded, followed by the remaining portion of the other program.

10:00	11:00	12:00
Program 1	CH10
	Program 2		CH40

Not recorded

EN41

CHECK PROGRAM DATA

	The PlusCode number you	VHS		PROGRAM 1
	entered and the matching		(VCR PLUS+ 12345678)
5 Timer-Recording informa-			START		STOP
		8:00PM			= 10:00PM
	tion is displayed on the	DATE			CH
	Program screen. Check to	12/24/00			12 SP
	make sure it’s accurate.	THU
		PRESS (8=DAILY, 9=WEEKLY
	● To change the stop time,	STOP+/– = STOP TIME, SP/EP)
		PRESS (OK) TO END
	press STOP +/–.

●To timer-record daily or weekly serials, press DAILY (NUMBER key “8”) or WEEKLY (NUMBER key “9”). “DAILY” or “WEEKLY” appears on the Program screen. Pressing the button again makes each corresponding display disappear.

●If you made a mistake, press CANCEL to access the VCR Plus+ screen again and input the correct PlusCode number.

●If the PlusCode number you inputted is incorrect, "ERROR" may appear on the screen to advise you of the error. This happens when the PlusCode number is for a program which has already passed. "ERROR" is displayed for about 5 seconds and the VCR Plus+ screen reappears.

SET TAPE SPEED

6 Press SP/EP (SP/LP for the DV deck).

RETURN TO NORMAL

SCREEN

7 Press PROG. or OK. "PROGRAM COMPLETED" appears on the screen for about 5 seconds, then normal screen appears.

ENGAGE TIMER MODE

8 Press TIMER. The VCR turns off automatically and "ä" is displayed on the display panel.

IMPORTANT

If you have moved to a different area or if a broadcasting station's channel number has been changed, the wrong VCR or CABLE CH number will be displayed on the VCR Plus+ program screen in step 5. When this happens, set the correct the Guide Channel number for that station. (☞ pg. 42, "Changing VCR Plus+® Setting")

NOTES:

●To disengage the timer before recording starts, press TIMER again. Pressing once more re-engages it.

●In case of a power failure after programming, the VCR’s memory backup keeps your selections for approximately 10 minutes.

●When timer-recording cable channels received through a Cable Box, be sure to keep the Cable Box set to ON.

●It is not possible to timer-record the same programme on both the VHS deck and the DV deck simultaneously.

●If the times that are programmed for recording on the DV deck and on the VHS deck overlap, the earlier start time takes precedence. If the start times are the same, the VHS deck takes precedence.