JVC Model HR-DVS1U manual Timer Recording, Possible Cause, Symptom, VHS deck, DV deck, TIMER again

							EN	71
RECORDING
		SYMPTOM		POSSIBLE CAUSE		CORRECTIVE ACTION
4. Audio dubbing is not possible.			● "SOUND MODE" on the DV Mode		Set "SOUND MODE" to "32kHz" at
			Set Menu had been set to "48kHz" at		the original recording (☞ pg. 33).
			the original recording.
			● The tape speed had been set to LP at		Set the tape speed to SP at the
			the original recording.		original recording.
5.	Monitoring the audio-dubbed		● This is normal.		Monitor the sound using the
	sound is not possible during audio				connected devices.
	dubbing using the DV deck.
6.	The programmed memory of		● The memory backup time has		Perform Random Assemble Editing
	Random Assmble Editing is		expired.		again.
	disappeared.
7.	When performing Tape Dubbing,		● This is normal.
	the beginning of the dubbing start
	point is not dubbed.
TIMER RECORDING
		SYMPTOM		POSSIBLE CAUSE		CORRECTIVE ACTION
1.	Timer recording won’t work.		● The clock and/or the timer have		Set the clock and/or timer correctly.
			been set incorrectly.
			● The timer is not engaged.		Press TIMER and check to make sure
					that ä appears on the front display
					panel.
			● The VCR has not been set up properly.		Re-perform the set-up procedures.
					Make sure you have compensated for
					Guide Channel and VCR or cable
					box channel number mismatches
					(☞ pg. 42).
2.	Timer programming won’t work.		● Timer recording is in progress.		Timer programming can’t be performed
					when timer recording is in progress.
					Wait until it finishes.
3.	ä and ] on the front display		● The timer is engaged but there’s no		VHS deck
	panel won’t stop blinking.		cassette loaded.		Load a cassette with the Record
					Safety tab intact, or cover the hole
					using adhesive tape.
					DV deck
					Load a cassette with the erase
					protection switch set to "REC".
4.	The cassette is automatically		● VHS deck		Remove the cassette and cover the
	ejected, and ä and ] on the		The loaded cassette has had its		hole with adhesive tape, or insert a
	front display panel won’t stop		Record Safety tab removed.		cassette with the Record Safety tab
	blinking.				intact.
			● DV deck		Remove the cassette and set the erase
			The loaded cassette has had its erase		protection switch to "REC".
			protection switch set to "SAVE".
5.	ä blinks for 10 seconds and the		● TIMER has been pressed when there		Check the programmed data and re-
	timer mode is disengaged.		are no programs in memory, or the		program as necessary, then press
			timer record program information		TIMER again.
			has not been programmed correctly.
6.	The cassette is automatically		● The end of tape was reached during		The program may not have been
	ejected, the power shuts off and ä		timer recording.		recorded in its entirety. Next time
	and ] won’t stop blinking.				make sure you have enough time on
					the tape to record the entire program.

CONTINUED ON NEXT PAGE