JVC Model HR-DVS1U Reset the Counter, Engage Insert Editing, Start Editing, END Insert Editing

TOP PLAY

INSERT PAUSE

.DUB A

T	W	3
1	2
		2
4	5	6
7	8	9
C.RESET	0	4
		PLAY
1	DV	VHS
STOP		PAUSE
	3

JOG/SHUTTLE

JOG

SHUTTLE

EN63

	RESET THE COUNTER
5	(VHS deck only)
	Press C.RESET to change the counter display to
	"0:00:00".
	LOCATE START POINT
	Determine the edit-in point (the beginning of the
	segment to be replaced) using the JOG/SHUTTLE
6 controls or pressing ª£and PAUSE.
	● Be sure to engage the Still mode at the edit-in point.

ENGAGE INSERT EDITING

7	Press INSERT.
	● Your VCR enters the Insert-Pause mode. ( , and
	light up on the front display panel.)
	● The TV screen changes from the still picture to the
	input source you are going to record.
	START EDITING
	Load the source cassette and play back the segment
	that is to be inserted. When you reach the start of the
8 section of the source tape that you wish to insert, press
	PLAY to start the tape in your VCR; Insert Editing begins
	at this point.

● and are displayed on the front display panel.

END INSERT EDITING

9 VHS deck

At counter "0:00:00", Insert Editing will stop automati- cally while the tape continues running in the Play mode. If you wish to stop Insert Editing before the specified edit-out point, press C.RESET.

DV deck

Press STOP to stop the tape in the DV deck.

FOR AV INSERT EDITING (VHS deck only)

If you want to replace the picture, Hi-Fi audio soundtrack and normal audio soundtrack all at the same time...

In step 7 above, after you press INSERT, press A. DUB. also. (andblink andlights up on the display panel.)

NOTES:

●Insert Editing cannot be performed on a VHS/S-VHS cassette that has had its record safety tab removed, or on a Mini DV cassette that has had its erase protection switch set to "SAVE".

●In insert editing, the recording speed (SP/EP) is determined by the previous recording to be replaced. If the previous recording's speed changes within a single edit, the inserted picture will be distorted at the switching point. (VHS deck only)

●A small portion of the recording which precedes an insert edit may become erased.

●Insert Editing is also possible using the rear connectors. When using these connectors, be sure to select the correct REAR AUX INPUT. To select the correct REAR AUX INPUT ("VIDEO" or "S-VIDEO"), follow steps 5 – 7 from the "Edit From A Camcorder" section, ☞ pg 57.

●Insert Editing is not possible using the DV IN/OUT connector.