Kenmore 385.19365 owner manual Changing Needle, To Remove and Attach the Foot Holder

Changing Needle

[_ Raise the needle by pressing the up/down needle	[]	[]
button and lower the presser foot,,
Turn off the power switch.,
Loosen the needle clamp screw by turning it
counterclockwise.
Remove the needle from the clamp.

[] Insert the new needle into the needle clamp with the flat side to the rear.

When inserting the needle into the clamp, push it up as far as it will go. Tighten the clamp screw firmly by turning it clockwise.

[] To check for a good needle, put the flat side of the needle onto something fiat (the needle plate, glass, etc.). The gap between the needle and the flat surface

should be consistent° Never use a bent or blunt needle. (_ Needle clamp screw

(_) Pin

® Needle clamp

[]

r/-7-7-7-// f / E /

k ...............................

To Remove and Attach the Presser Foot

[][]

[] Press the red button on the back of the foot holder,. The presser foot wilt drop off,

[] Place the selected presser foot so the pin on the foot

lies just under the groove of the foot holder, Lower the

presser bar to lock the foot in place,				@___/
	0	Red button		, *.1%t
	(_) Groove
	®	Pin
To Remove and Attach the Foot Holder
[]	To Remove:		[]	[]
	Remove the thumb screw by turning the screw counter-
	clockwise with the screwdriver.
[]	To Attach:
	Match the hole in the foot holder with the threaded hole
	in the presser bar,
	Fit the thumb screw into the holeo
	Tighten the screw by turning clockwise.			®
	O Thumb screw
	(_) Foot holder
	®	Presser bar

26