Various Utility Stitches

Basting

OStitch pattern:
Thread tension dial:
(_)P: Embroidery foot
!9
t to 3 J
!
19 1_"4 P3.5

Attaching the Embroidery Foot

[] Raise the needle
[j_Remove the foot holder by loosening the thumb
screw.
[] Attach theEmbroidery foot on the presser bar
puttingthe pin on the needle clamp_ Tighten the
thumb screw firmlywith alarge screwdriver,.
0Foot holder
QThumb screw
_) Pin
Needle clamp
f
[]
J
d

°Starting to sew

[_ Lower the feed dogs by switching the drop feed lever to
the right,, (See page 24)
[] Set the thread tension dial between 1 and 3o
[_ Put some fabric under the foot andpress Up/down
needEebutton twice to bring the needle thread down
through the hole inthe foot,. Pull the fabric and thread
to the rear. Lower the presser foot°
[] While pressing clown the foot control, gently pull and
guide the fabric.
[] When the machine isstopped after I stitch sewing,
pull the threads and fabric to the near side and cut the
threads.
[] Repeat steps [] to[] tosew. Afrer finishing sewing,
pull the threads and fabric to the rear sider
'*,_, J
* After sewing, reset the thread tension dial at "AUTO"
and raise the feed dogs, slide the drop feed lever to
the left.
52