Table of Contents, continued
3.14 | Genset System Menu | 40 | |
3.15 | ATS Status Menu | 41 | |
3.16 | ATS Configuration Menu | 42 | |
3.17 | Date and Time Menu | 43 | |
3.18 | Networking Information Menus | 43 | |
| 3.18.1 | Networking Status Submenu | 44 |
| 3.18.2 | Networking Configuration Submenu (OnCue Plus Password) | 45 |
| 3.18.3 | RBUS Information | 47 |
| 3.18.4 | Remote Devices Submenu | 48 |
3.19 | Programmable Interface Module (PIM) Status Menu | 49 | |
3.20 | Load Control Module (LCM) or Load Shed Kit Menus | 50 | |
3.21 | Event Log | 51 | |
Section 4 DC2 Controller Operation | 53 | ||
4.1 | DC2 Generator Set/ Transfer Switch Controller | 53 | |
4.2 | Controls and Indicators | 53 | |
| 4.2.1 | Controller Keypad | 54 |
| 4.2.2 | LED Indicators | 54 |
| 4.2.3 | LCD Display | 55 |
4.3 | Controller Power | 55 | |
4.4 | Battery Charging | 55 | |
4.5 | Exercise | . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . | 56 |
| 4.5.1 | Exercise Modes | 56 |
| 4.5.2 | Setting the Exerciser | 56 |
| 4.5.3 | Exerciser Reset | 56 |
4.6 | Event Log | 56 | |
4.7 | Maintenance Timer | 57 | |
4.8 | OnCue Plus Password | 57 | |
Section 5 Scheduled Maintenance | 59 | ||
5.1 | Scheduled Maintenance | 60 | |
| 5.1.1 | Service Schedule | 61 |
5.2 | Lubrication System | 62 | |
| 5.2.1 | Low Oil Pressure Shutdown | 62 |
| 5.2.2 | Oil Check | 62 |
| 5.2.3 | Engine Oil Recommendation | 62 |
| 5.2.4 | Oil Change Procedure | 62 |
| 5.2.5 | Resetting the Maintenance Timer | 64 |
5.3 | Spark Plugs | 64 | |
5.4 | Air Cleaner Service | 65 | |
| 5.4.1 | Air Cleaner, 8RESV/RESVL Models | 65 |
| 5.4.2 | Air Cleaner, 10/12RESV/RESVL Models | 66 |
5.5 | Cooling System | 66 | |
5.6 | Exhaust System | 67 | |
5.7 | Battery . | . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . | 68 |
5.8 | Storage Procedure | 69 | |
| 5.8.1 | Lubricating System | 69 |
| 5.8.2 | Fuel System | 69 |
| 5.8.3 | Cylinder Lubrication | 69 |
| 5.8.4 | Exterior Preparation | 69 |
| 5.8.5 | Battery | 69 |
Section 6 Troubleshooting . . . | . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . | 71 | |
6.1 | Introduction | 71 | |
6.2 | USB Port | 71 | |
6.3 | Fault Messages | 71 | |
6.4 | Circuit Protection | 71 | |
| 6.4.1 | Controller Internal Circuit Protection | 71 |
| 6.4.2 | Line Circuit Breaker | 71 |
| 6.4.3 | Auxiliary Winding Circuit Breaker | 71 |
6.5 | Troubleshooting | 72 | |
Appendix A Abbreviations | . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . | 73 | |
Table of Contents |
