Lantronix 2100E Connection Settings UDP, Disconnect Mode, To configure a channel’s UDP settings

4: Web Manager Configuration

LED

connects, the unit stops trying to connect to any others. If this connection fails, the unit continues to scroll through the table until it is able to connect to another IP in the host list.

The host list is disabled for Manual and Modem Modes. The unit will not accept a data connection from a remote device when the host list option is enabled.

Select Blink for the status LEDs to blink upon connection, or select None for no LED output.

Disconnect Mode

On Mdm_Ctrl_In Drop	Set to Yes for the network connection to or from the serial port to
	disconnect (drop) when Modem Control In transitions from an
	asserted state to not asserted state. The default setting is No.
Hard Disconnect	When set to Yes, the TCP connection closes even if the remote site
	does not acknowledge the disconnect request.
Check EOT (Ctrl+D)	Choose Yes to drop the connection when Ctrl+D or Hex 04 is
	detected. Both Telnet Com Port Cntrl and Disconnect with EOT
	must be enabled for Disconnect with EOT to function properly. Ctrl+D
	is only detected going from the serial port to the network.
Inactivity Timeout	Use this parameter to set an inactivity timeout. The unit drops the TCP
	connection to port 10001/10002 if there is no activity on the serial line
	before the set time expires. Enter time in the format mm:ss, where m is
	the number of minutes and s is the number of seconds. To disable the
	inactivity timeout, enter 00:00.
	Note: The default port number for Port 1 is 10001 and 10002
	for Port 2. However, port numbers may be set to a different
	value.

3.When you are finished, click the OK button.

4.On the main menu, click Apply Settings.

Connection Settings - UDP

To configure a channel’s UDP settings:

1.From the main menu, click Connection for either Channel 1 or Channel 2 to display the Connection Settings page for the selected channel.

Connect Protocol

Protocol

Select UDP from the pull-down menu.

WiBox® 2100E Device Server User Guide 38