Lantronix 2100E manual To enable the hostlist, Autostart Automatic, Hostlist

	7: Setup Mode: Channel Configuration
Autostart (Automatic	If you enable Autostart, the unit automatically connects to the
Connection)	remote IP address and remote port specified when the firmware
	starts.
Hostlist	If you enable this option, the device server scrolls through the
	hostlist until it connects to a device listed in the hostlist table.
	Once it connects, the unit stops trying to connect to any others. If
	this connection fails, the unit continues to scroll through the table
	until it is able to connect to another IP in the hostlist.
	Hostlist supports a minimum of 1 and a maximum of 12 entries.
	Each entry contains the IP address and the port number.
	The hostlist is disabled for Manual and Modem Modes. The unit
	does not accept a data connection from a remote device when
	the hostlist option is enabled.
	Figure 7-2. Hostlist Option

Baudrate (9600) ?

I/F Mode (4C)

Flow (00) ?

Port No (10001) ?

ConnectMode (25) ?

Send ‘+++’ in Modem Mode (Y) ?

Auto increment source port (N) ?

Hostlist		:				Port : 00023
01.	IP : 172.019.000.001
02.	IP : 172.019.000.002					Port : 03001
03.	IP : 172.019.000.003					Port : 10001
Change Hostlist ? (N) ? Y							Port : (23)
01.	IP address :			(172)	.(019) .(000) .(001)
02.	IP address :			(172)	.(019) .(000) .(001)		Port : (3001)
03.	IP address :			(172)	.(019) .(000) .(001)		Port : (10001)
04.	IP address :			(000)	.(000) .(000) .(000)
Hostlist		:				Port : 00023
01.	IP : 172.019.000.001
02.	IP : 172.019.000.002					Port : 03001
03.	IP : 172.019.000.003					Port : 10001
Change Hostlist ? (N) ? N
Hostlist Retrycounter					(3)
Hostlist Retrytimeout					(250)
DisConnMode (00)
FlushMode			(00)
DisConnMode (00:00) ?:
SendChar 1			(00)	?
SendChar 2			(00)	?

To enable the hostlist:

1.Enter a Connect Mode of 0x20 (2X), where X is any digit. The menu shows a list of current entries already defined in the product.

2.To delete, modify, or add an entry, select Yes. If you enter an IP address of 0.0.0.0, that entry and all others after it are deleted.

3.After completing the hostlist, repeat the previous step if necessary to edit the hostlist again.

WiBox® 2100E Device Server User Guide 55